Windows 10: Blue Screen Appears then Freezing then Pc stops turning on

I was writing a assignment on my pc when a blue screen error message shows upsaying its going to restart and needs to collect my data or something with a percentage showing on the sidethe percentage always stayed on 0 and didnt do anything so i unplugged my power cableafter replugging it, my pc seemed to be normal however after i signed in and put my password,the screen froze and no keybinds were working so i unplugged the power cable again however after replugging when i tried to turn on my pc, the pc wouldnt turn on, instead the lights and fans would work for a few seconds before the entire

:)

 

Computer Freezes Then Blue Screen

Hello,

A stop error (also called a "blue screen" error) can occur if a problem causes your PC to shut down or restart unexpectedly. These errors can be caused by both hardware and software issues.

For us to better assist you, we'd like to know the following:

• Confirm which build is currently installed on your device. To check, follow the steps below:

• Press Windows key + R, then type in winver.
• Click OK.

• Were there any recent changes made prior to this issue?
• What is the make and model of your device?

Meanwhile, we suggest performing the steps on this article
on how to troubleshoot blue screen errors on Windows 10.

We look forward to your response.

Regards.

 

PC Build Steps

Ok just because I like steps i am going to create some steps. Please give me the stamp of approval/disapproval

• Install system in case
  • Remember to connect SSD and optical to same SATA ports on motherboard
• Turn on PC
• setup HDD
• run blend test in prime95 for 30-60 min
  • run realtemp at the same time

• While in Prime95 test
  • if CPU goes above 70c in RealTemp, I have a leaky CPU
  • if my system locks up or blue screens, there is an instability in the system somewhere
  • if my system does not lock up or blue screen, my CPU is not damaged and I am in the clear!

What do you guys think??

 

Blue screen and stop code

Hi
Jeferis,

There are a lot of factors for this matter to occur. To isolate the issue, we have some questions for you:

• 
  What activity have you done to
  trigger the NTFS and FAT FILE SYS loop?
  
• 
  were there any error messages?
  
• 
  What troubleshooting steps have you done so far?
  

It is possible that the
Boot
Sequence were corrupted by the previous activity which
triggered the Blue Screen Error and the loop. We recommend that you perform these
suggested troubleshooting
and see if there are any changes:

Startup Repair.


To access the
Startup Repair Screen, turn off the
PC 3-4 times(force shutdown),
while on the Blue screen Error. This will route you to the
Startup repair screen:

Advanced Boot Options > click Troubleshoot > Advanced options > Command Prompt

and run the following command:

Run SFC Scan:  

SFC
will
scan
and
run
an
automatic repair
to any
corrupted system files
that it will detect. We suggest that you perform it twice. To run an
SFC scan, follow these steps:  

• 
  Run
  Command Prompt as Administrator.  
  
• 
  Type
  sfc /scannow
  and hit
  Enter.   
  

Boot Record:

This will fix the corruptions on
boot records or boot
sequence. To run this command, follow these steps:

• 
  Run
  Command Prompt as Administrator.
  
• 
  Type the following command:  
  
  • 
    Bootrec /fixMBR  
    
  • 
    Bootrec /fixBoot
    
  • 
    Bootrec /rebuildBCD
    

Update us on how it goes.

Regards.