Windows 10: Blue screen at every boot

Hello!

Since quite some time, I have been receiving a BSOD with "driver power state failure" message.

I am using a Toshiba Satellite L50-A-16Q upgraded to Windows 10.

From the beginning I have 2 GB of RAM installed in addition, from an old PC.

However, the Blue Screen didn't appear for a long time even with the sticks of RAM added.

I have tried anything to solve it, but it always appeared. I tried to check in Safe Mode for wrong drivers, but it only shows a warning regarding "Generic Pnp Monitor" that seems to be the only one compatible.

This is the link for downloading the minidump of the error: https://drive.google.com/open?id=1VOGolKWV7yOwzATKfg6uFSIhwK7N8-1C


This is the report of the BSOD from BlueScreenView:


I have no clue how to solve it now. Can anyone please help?


Thank you so much!


Matteo

:)

 

Startup Blue Screen

Hi Jon,

Startup blue screen error(s) can occur if a problem causes your PC to shut down or restart unexpectedly. It could be due to the following:

• Outdated device software drivers
• Corrupted Windows update system files
• Software/Security conflicts

We would like to know some information:

• Did you get any blue screen stop error codes?
• Have you tried booting in Safe mode?

We suggest that you check this
article about troubleshooting blue screen errors and follow the troubleshooting steps provided there.

We will wait for your response

 

Blue screen and stop code

Hi
Jeferis,

There are a lot of factors for this matter to occur. To isolate the issue, we have some questions for you:

• 
  What activity have you done to
  trigger the NTFS and FAT FILE SYS loop?
  
• 
  were there any error messages?
  
• 
  What troubleshooting steps have you done so far?
  

It is possible that the
Boot
Sequence were corrupted by the previous activity which
triggered the Blue Screen Error and the loop. We recommend that you perform these
suggested troubleshooting
and see if there are any changes:

Startup Repair.


To access the
Startup Repair Screen, turn off the
PC 3-4 times(force shutdown),
while on the Blue screen Error. This will route you to the
Startup repair screen:

Advanced Boot Options > click Troubleshoot > Advanced options > Command Prompt

and run the following command:

Run SFC Scan:  

SFC
will
scan
and
run
an
automatic repair
to any
corrupted system files
that it will detect. We suggest that you perform it twice. To run an
SFC scan, follow these steps:  

• 
  Run
  Command Prompt as Administrator.  
  
• 
  Type
  sfc /scannow
  and hit
  Enter.   
  

Boot Record:

This will fix the corruptions on
boot records or boot
sequence. To run this command, follow these steps:

• 
  Run
  Command Prompt as Administrator.
  
• 
  Type the following command:  
  
  • 
    Bootrec /fixMBR  
    
  • 
    Bootrec /fixBoot
    
  • 
    Bootrec /rebuildBCD
    

Update us on how it goes.

Regards.

 

Blue Screen

Hi,





Blue screens could be caused by problems with your computer’s hardware or with its driver. Still, we
would like to know more about the issue. Please clarify the following:

• Did you get a STOP code?
• Did you install any hardware or driver recently?

For basic troubleshooting steps to resolve blue screen errors, we suggest checking out this
article and simply follow the steps.



Feel free to contact us if you need further help.