Windows 10: Blue Screening a short time after boot or when transfering large amount of files

Recently my computer has started blue screening about 30 min to an hour after booting. I noticed that my computer has noticeably gotten slower and blue screens happen when I was transfering files or when too many windows were open.


Some background info just incase it proves to be useful. I recieved a GTX960 to replace my GTX950 and I installed it and downloaded the drivers. Turns out the

fans on the 960 were not working so I reinstalled my 950 and downloaded drivers again. I also replaced the thermal paste on both cards.


Firstly I suspect its my hard drive because that's the oldest part I have in my PC and needs to be replaced. I ran CrystalDisk and gave me a Caution with current pending sector count and uncorrectable sector count at 274. I also ran memtest86 and I recieved no errors from it. Now I'm here to post my dump file since I do not know what else to do and want to check what really is wrong.


https://drive.google.com/file/d/1k3X4rjLtG4hwY56Dk8zK-2lPJKmHM3wr/view?usp=drivesdk


Thank in advance.

:)

 

Blue screen and stop code

Hi
Jeferis,

There are a lot of factors for this matter to occur. To isolate the issue, we have some questions for you:

• 
  What activity have you done to
  trigger the NTFS and FAT FILE SYS loop?
  
• 
  were there any error messages?
  
• 
  What troubleshooting steps have you done so far?
  

It is possible that the
Boot
Sequence were corrupted by the previous activity which
triggered the Blue Screen Error and the loop. We recommend that you perform these
suggested troubleshooting
and see if there are any changes:

Startup Repair.


To access the
Startup Repair Screen, turn off the
PC 3-4 times(force shutdown),
while on the Blue screen Error. This will route you to the
Startup repair screen:

Advanced Boot Options > click Troubleshoot > Advanced options > Command Prompt

and run the following command:

Run SFC Scan:  

SFC
will
scan
and
run
an
automatic repair
to any
corrupted system files
that it will detect. We suggest that you perform it twice. To run an
SFC scan, follow these steps:  

• 
  Run
  Command Prompt as Administrator.  
  
• 
  Type
  sfc /scannow
  and hit
  Enter.   
  

Boot Record:

This will fix the corruptions on
boot records or boot
sequence. To run this command, follow these steps:

• 
  Run
  Command Prompt as Administrator.
  
• 
  Type the following command:  
  
  • 
    Bootrec /fixMBR  
    
  • 
    Bootrec /fixBoot
    
  • 
    Bootrec /rebuildBCD
    

Update us on how it goes.

Regards.

 

Startup Blue Screen

Hi Jon,

Startup blue screen error(s) can occur if a problem causes your PC to shut down or restart unexpectedly. It could be due to the following:

• Outdated device software drivers
• Corrupted Windows update system files
• Software/Security conflicts

We would like to know some information:

• Did you get any blue screen stop error codes?
• Have you tried booting in Safe mode?

We suggest that you check this
article about troubleshooting blue screen errors and follow the troubleshooting steps provided there.

We will wait for your response

 

Blue Screen Will Not Boot Up

removed both sticks of memory maybe loose or dusty retry 1 at a time still will not boot
only blue screen tried to boot safe mode still same