Windows 10: BlueScreen after installing M.2

Hi everyone!I have this problem and I hope someone could have an answer:Every time I try to install a new M.2 hard disk I tried 3 of them in 3 years my Windows both Win 10 and Win 11 starts randomly crashing Blue Screen.When I go back to a SSD , zero problem and zero Blue Screen. What could it be?I checked the System events and it says:ID EVENT 41KERNEL-POWERGENERAL "Restarting the system without a graceful shutdown. This error can be caused by an unexpected system outage, crash, or power failure." google translate from italianThanks in advance,FUSK.

:)

 

M.2 SSD not being able to boot from it, windows doesn't recognise.

Ok, this is what happened after all the comments and suggestions, @dude: Thanx for the video, my mb had non e of those settings, it had the raid/option memory gene or achi. Can only choose one or the other. @Saltgrass, my settings did point out auto and enabled the pcie x4, gen 3. I did an bios flash as suggested, because my bios was not the latest version, after a reformat the m.2 was picked up, still cant install OS onto it as it states legacy not found, removed my dvd rom from the sata port to another, and the drive was found and installed. Only issue now is that it's still not my OS drive but it at least now works and is installed, but on the Intel rst drive the obtain memory gene option to enable is greyed out, and shows as disabled. However the program lists the M.2 and it is working 100%,. I installed overwhatch onto it, it performs perfectly. But will update the intel driver tonight and see if that makes any difference. Seems the bios flash enabled the settings listed by @dude that was not present pre-flash.

So the m.2 drive works. I can game off it and install omnto it. Can not install windows on it, gene memmory is enabled, pcie x4 is on and on auto detect, Motherbaord lists all the drives connected, motherboard ahs been updated to latest bios. After flash new settings became available, m.2 is now on memmory gene enabled not achi, windows os is enabled and fast boost is enabled, intel rst is installed and lists all the ssds and the m.2, however the m.2 on memmory gene is dissabled and the option to enable is greyed out. Will update the driver as Essenbe suggested of the m.2 and see if anything changes. Thank you all for the help, I can now atleast use my m.2

 

A new win install on a HDD messed up my win install on my m.2 SSD




- - - Updated - - -

Yes, I do think that is my problem, but I couldn't find a way to remedy it. Sorry for the screenshot being in Hungarian, if you need I can translate it. And don't mind the 500 MB partition, I tried to do a fix from a similar thread which suggested creating it, but later steps didn't prove successful.

 

No Boot, Drives Not detected, Can't Load Win10 Pleses Help!

Until the BIOS sees your M.2, there's nothing you can do. It does not matter if the M.2 is unformatted/unallocated, the BIOS should see it.

1. Suggest that you take the M.2 out, clean all the contacts and re-seat it and hope this is the case.
2. If step one fails. Connect your 250GB SSD back in using one of the SATA port to see if the BIOS recognize it. If it doen't, then it might be something wrong with the MB, if it does then boot up the Windows Installation USB, run diskpart, shrink it at least 40GB then create a partition, Leave it unallocated then install Windows there.

Also try to re-seat all other components such as Memory, Video card etc...