Windows 10: Bluetooth Issue after CU update

Hi, right after doing the CU update, i paired again my bluetooth keyboard and now I have some issues with it,

When i'm away for like 10 minute my keyboard is going to "sleep mode" to use less battery as possible so it's not connected to bluetooth anymore but when I push any (for exemple "K" letter) button it goes on again and connect to the bluetooth of the computer and type the button i pushed.. So it's acting normal but since the CU update when i push a button after my keyboard going to sleep mode the computer freeze like completly for like 1-2 seconde and then it type the button/letter i pushed

In anniversary update I didn't had this issue, it acted normally .. I mean no freeze just needed a few second to the keyboard to goes out of sleep then giving the signal of the button i pushed so basically 1 sec of delay and then act like a normal keyboard with no delay, but like I said after the CU update these 1 second of delay now is 1-2 second of freezing the computer..

I didn't change anything since the update, nor the Bluetooth dongle, nor installed a new driver, nor even changed the USB that the dongle is connected too (even if i tried different usb after i found the freezing issue is coming from the bluetooth) ...

Anyone having the same experience/issue ? Or somebody could help on this ?
The dongle is "Trust Bluetooth 4.0 Dongle" i bought 1 year ago at MediaMarkt in belgium

:)

 

Shift+Delete causes explorer.exe crashing and restarting

Yeah. If I rollback to RS1, all work fine. But my computer keeps telling me to update to 1703(Creators Update, CU for short). And I do want to experience new features in CU. How would I do?

This issue only happened when my computer was CU updated.

I doubt that an incompatibility will cause explorer.exe crashing with SHIFT+DELETE operation. I still cannot believe that CU is a release version. It looks like a beta one to me.

There're still 2 more issues:

1. "winver" wont work.

2. CSR bluetooth driver crashes occasionally.

 

defender issue after CU

just updated to the Win 10 Creator Update, so no older updates show up to run DISM, so you get an error msg with it.

went thru troubleshooter

ran sfc /scannow with no errors