Windows 10: Boot Drive messed up? please help!

So, I was doing the Guru3D Display Driver Uninstaller, and I did all that, and it restarted and then it says “A disk read error occurred, press ctrl alt del to restart”

and i don’t know what to do!!!!

submitted by /u/FalconzBeast
[link] [comments]

:)

 

laptop doesnt boot automatically

This is what happened.

1. Did a repair install and later disabled hibertnate in CMD.
2. Enabled legacy option ROM in BIOS.
3. After a few times startup ( i used the system in such mode for 5 days), changed boot option back to default.
4. Vola!! It boots automatically to win10 without any keypress. Tested it with many starts to confirm the same.
5. Re-enabled hibernate option using CMD and later selected Fast Startup.
6. System booted normally, without the need for any keypress.

I do not know exactly whether such steps resolved the problem or what else happened, hence cannot suggest above steps.

Many thanks to all members who helped to troubleshoot problems.

 

help to remote connect

not sure how to use both programs u 2 suggested, i need more helpful steps thanks

 

No Boot, Drives Not detected, Can't Load Win10 Pleses Help!

Until the BIOS sees your M.2, there's nothing you can do. It does not matter if the M.2 is unformatted/unallocated, the BIOS should see it.

1. Suggest that you take the M.2 out, clean all the contacts and re-seat it and hope this is the case.
2. If step one fails. Connect your 250GB SSD back in using one of the SATA port to see if the BIOS recognize it. If it doen't, then it might be something wrong with the MB, if it does then boot up the Windows Installation USB, run diskpart, shrink it at least 40GB then create a partition, Leave it unallocated then install Windows there.

Also try to re-seat all other components such as Memory, Video card etc...