Windows 10: Bought a used phone online. Few years later... Did a factory reset, and now it is asking me...

Tried with the account I signed on here with and it is telling me I can't use a personal account for it. WTH am I suppose to do now?

:)

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

Ive factory reset my computer but I can't use the mouse or the keyboard to select laugage

Hi,

A device like your keyboard and mouse is not detected during factory reset.
To help us determine the appropriate troubleshooting steps
that can resolve your concern, we would like to ask the following questions:

• Are you performing a factory reset on a laptop or a desktop?
• Is this the first time you perform a factory reset on your device?
• What troubleshooting steps have you done so far to resolve your concern?

In the meantime, if you're working on a desktop, we suggest that you try to use a PS2 keyboard just to bypass the installation process. Once Windows is up and running, you may now plug your mouse and keyboard to initialize Windows to detect these devices.

We look forward to your response.

 

Dell Inspiron 15 stuck in factory reset loop

I have a Dell Inspiration 15 with win 10. it was bogged and slow as syrup on 125 degree day. I did a factory reset. I followed the instructions went to settings, and just followed the steps. At some point during the reset it asked me about tpm2 settings...I had never seen that before so I followed the recommended choice and went to bed. When I got up it asked me for the usual stuff, location, language, time zone. Then it wanted the name of my WIFI and my password, which I gave. It restarted, then just kept on restarting asking me the first set of questions, language, time zone...over and over, it never asked for internet name or password again, . I can get in to the bios settings by using the f8 key.
Any suggestions? Hopefully...
OH I almost forgot, when you do a hard restart, it flashes a tpm2 settings error right before it starts with the dell screen and spinning dots