Windows 10: BSOD After Installing New SSD SATA

Hye, I just installed my SATA SSD for an extra storage, after install and apply the volume, for a few minutes its suddenly crashBefore i install my SATA SSD i have an M2 and it works perfectly fine, but then its starts BSOD after i add a new SATA SSDThen i try to uninstall the SATA SSD from my pc and start run my pc without the SATA SSD, its still bsodSupposedly it wont crash since i didnt use the additional ssd but only using my m2 storage, but its still crash when im only using M2Please help, its been a week i try to solve this problem

:)

 

SATA SSD and M.2 SSD

i was with a ssd sata and now i have ssd m.2, i formatted and put windows 11 in m.2, but i did not remove the ssd sata, i can only boot windows with the ssd sata connected, if i remove it windows does not boot to m.2



obs: windows was installed on m.2 but the ssd sata was still connected, but windows was 100% installed on m.2, is there any way I can set m.2 as primary? (when i removed the ssd sata it did not recognize windows)

Sorry for my bad English

imgur.com

 

SATA HDD recognised as SSD

Hi. My SATA HDD is recognised as a SSD and Windows 10 will not perform defragmentation on it as a result; which I appreciate. I've tried many of the prescribed procedures mentioned on forums but to no effect. I'm pretty convinced that the problem lies
in the fact I have installed a SSD in my machine. Windows is recognising the correct size of my SATA HDD however and the SSD isn't showing up quite rightly as its Linux formatted. Using a third party defragmentation program exactly the same problem occurs,
however I was able to defragment my C drive using it as it just warned against it and didn't prohibit me. Any suggestions would be greatly appreciated.

 

Install Windows 10 on SATA SSD

My SSD isn't getting recognized by the Windows 10 installer.

I'm installing from a USB using the official installation creator.

Here are the steps I've already taken:

1) Used DISKPART to clean and create a NTFS partition on the drive. It is listed when using SHIFT+F10 -> LIST DISK. The partition has been set to ACTIVE.

2) Downloaded a load of drivers from the motherboard's website and browsed and tried those when asked. After I click the next button is just says no drivers were found, and the cycle continues.

3) Tried various USB ports for the installer.

4) Set the SSD to both SATA and IDE modes in the BIOS.

My motherboard is an ASUS M5A97 EVO R2.0.

As I try other methods I think of/try I'll update this question.