Windows 10: BSOD before and after enabling TPM2.0

Been having this problem for a while after enabling TPM2.0 to upgrade to Windows 11, after getting the BSOD I disabled TMP and reset my CMOS, and re-installed windows and I'm still getting the same problems. I don't know what else to do. What else can I try? Everything was fine before trying to upgrade to Win11, I reset the computer once already with TPM disabled, don't know what else it can be.PC Specs IntelR CoreTM i9-10900K CPU @ 3.70GHz 3.70 GHz32GB Ram13Tb of Storage3060TI GPUMEG Z490 Ace MS-7C71 MotherboardWindows 10 Home

:)

 

Getting BSOD 0x124 error

Ignore what everone said here.

0x124 BSOD is usually related to VCCIO (VTT), run Prime95 version 26.6 with custom sizes of 512K to 640K with 50% of your memory for at least 8 hours.

If you get a 0x124 BSOD, increase VCCIO voltage by small steps, run Prime95 again until your stable.

If you pass Prime95 512K to 640K without a BSOD, then its Vcore too low. I'd suggest running IntelBurnTest with 80% of your memory to verify stability (8 to 12 hours).

Oh, and yeah, if this problem appeared all of the sudden, the reason is CPU degradation, you can prevent it by enabling C-States or adjust your overclock to use lower voltages.

 

Raid 0 help

Hi all, I've followed the IRST raid installation directions and I have created myself a Raid 0 volume. Rapid storage confirms my successful migration from a system disc to a raid 0 array. I'm also able to select it as my boot device in BIOS, but what I don't understand is why it is not listed in my Drives under my computer

In fact, my computer still lists my original C: drive with the original capacity. I feel as if I've miss an important step here and I'm unsure how to proceed.

 

Intel Updates Core 2 Quad Q9550 to E-0 Stepping

We continue our Monday news list with another Intel story that brings to our attention information concerning the company and more specificly its 2.83GHz Core 2 Quad Q9550 chips that will move from the current C-1 to the newer E-0 stepping. The updated chips will start selling on August 22nd, featuring the following changes:

• New SSpec and MM numbers for the converting products
• CPUID will change from 0x10677 to 0x1067A
• Package change to Halide free package

Apart from that, the new stepping CPUs will not include any other changes. Of course, like most new stepping parts a BIOS update will be needed.


Product Change Notification 108663 - 00

Source: TechConnect Magazine