Windows 10: BSOD error run few test still cant find it.

Hello, i think ive got few errors this few days but seem i cant find the problem.run minitool for disk checking no bad sectors,then run sfc and dism check no problem too,the last run windows memory diagnostic still no problem,untill that only i can provide is below memory dump please check whats is the problem?Stopcode:SYSTEM_SERVICE_EXCEPTIONCRITICAL_PROCESS_DIEDMinidump:https://drive.google.com/file/d/1uO2kXqFtWTcYA-E7u7KuCCSCF5Q8XSLD/view?usp=sharing

:)

 

BSOD - Registry Error

Your BSOD code is 0X000000051

Here's the Google search I did for it: https://www.google.com/search?q=0x0...j5.399j0j7&sourceid=chrome&es_sm=122&ie=UTF-8

There is a hotfix available that might help, https://support.microsoft.com/en-us/kb/810558

This thread makes a few good suggestions too: http://www.sevenforums.com/bsod-hel...dows-7-pro-sp1-registry-error-0x00000051.html

+1 to listing your full system specs, OS version, etc. I did only look at your BSOD log file.

Run a Diskchk /R (I know you already ran one, so you can skip this)

Run SFC /SCANNOW

Report back.

 

Getting BSOD 0x124 error

Ignore what everone said here.

0x124 BSOD is usually related to VCCIO (VTT), run Prime95 version 26.6 with custom sizes of 512K to 640K with 50% of your memory for at least 8 hours.

If you get a 0x124 BSOD, increase VCCIO voltage by small steps, run Prime95 again until your stable.

If you pass Prime95 512K to 640K without a BSOD, then its Vcore too low. I'd suggest running IntelBurnTest with 80% of your memory to verify stability (8 to 12 hours).

Oh, and yeah, if this problem appeared all of the sudden, the reason is CPU degradation, you can prevent it by enabling C-States or adjust your overclock to use lower voltages.

 

RPi2 from Windows cross compilation Error "The test for linking against libxcb failed!"

Error in Cross Compilation, I am using Qt5.0, Windows10, Raspberry Pi 2.
I was following this tutorial and the process failed at step 16 and tried with its suggestion but cannot find a solution.

Error prompted after step 16 is:

Running configuration tests...
The test for linking against libxcb failed!
Use of pkg-config is not enabled, maybe you want to pass -force-pkg-config?
You might need to install dependency packages for libxcb.
See src/plugins/platforms/xcb/README.

and when I printed log in file as tutorial suggested, there are some errors mentioned like:

• cc1plus.exe: error: unrecognized command line option '-fuse-ld=gold'
  
• error "Symbolic function binding on this architecture may be broken, disabling it (see QTBUG-36129)."
  
• etc.
  

I tried but still find no solution.