Windows 10: Bsod errors in win 11

After downloading the cumulative updates for June,i.e,06-23, my laptop-HP pavillion i5 is causing multiple bsod errors mainly relating to memory like , page fault in non paged area , kernel security check failed , etc pls help

:)

 

BSOD - Registry Error

Your BSOD code is 0X000000051

Here's the Google search I did for it: https://www.google.com/search?q=0x0...j5.399j0j7&sourceid=chrome&es_sm=122&ie=UTF-8

There is a hotfix available that might help, https://support.microsoft.com/en-us/kb/810558

This thread makes a few good suggestions too: http://www.sevenforums.com/bsod-hel...dows-7-pro-sp1-registry-error-0x00000051.html

+1 to listing your full system specs, OS version, etc. I did only look at your BSOD log file.

Run a Diskchk /R (I know you already ran one, so you can skip this)

Run SFC /SCANNOW

Report back.

 

Getting BSOD 0x124 error

Ignore what everone said here.

0x124 BSOD is usually related to VCCIO (VTT), run Prime95 version 26.6 with custom sizes of 512K to 640K with 50% of your memory for at least 8 hours.

If you get a 0x124 BSOD, increase VCCIO voltage by small steps, run Prime95 again until your stable.

If you pass Prime95 512K to 640K without a BSOD, then its Vcore too low. I'd suggest running IntelBurnTest with 80% of your memory to verify stability (8 to 12 hours).

Oh, and yeah, if this problem appeared all of the sudden, the reason is CPU degradation, you can prevent it by enabling C-States or adjust your overclock to use lower voltages.

 

Win 10 BSOD while using

Did upgrade to Win 10 over a month ago. This morning my Lenovo T410 laptop had the BSOD with Error=0xc000000f on it (it does backups overnight). I've run diags on the hardware (mem, motherboard bus, PCI bus and HDD) all PASS. Tried using my repair disk
(built in Jan with Win7) and was unable to recover. I checked for bad sectors and found none. From CMD prompt I did DISKPART and LIST VOLUME and all volumes say HEALTHY but I see that my C: drive (primary partition) says it is RAW (instead of NTFS). My backup
media is a network attached (NAS) disk and I used Cobian 11 Backup. Not sure what my next step would be. Looking for suggestions before I have to restore to Win7 and re-upgrade, etc.