Windows 10: BSOD issues

Been consistently getting BSODs while watching videos online. Error message says “system thread exception not handled” caused by “netwsw00.sys” file. Whocrashed says it comes from the intel wireless wifi link adapter. Tried updating drivers and rolling back to earlier ones but nothing has made a difference. Will still happen on a fresh install of windows without any other programs installed. Don’t remember having these issues on windows 8.1. Using a dell Xps 17 l702x laptop

submitted by /u/unclefreddysweinis
[link] [comments]

:)

 

AMD FX OC'ers Club

That's what the auto setting will do since you're over the 1333 mark it jumps to the next step which isn't listed or officially supported I assume by that ram.

At this point though I would suggest dropping the multi one step or .5 so that we can get something stable and possibly take the heat issue out of the picture for now.

 

BSOD- atikmpag.sys

This is most likely due to an installation/upgrade error with ATI driver's. I suggest doing DriveSweeper and the following:

• Drivesweeper all drivers & in Safe Mode
• Unistall all drivers that aren't used in DriveSweeper (CCC Profiler Updates, MSI AfterBurner, anything related to ATI that use's it's drivers.)
• After you do this, the first thing you need to do is go into Device Manager and Unistall your ATI Drivers

Once your done, restart the PC and then try installing the latest drivers.


I had several issues with this in the past, but I overcame it with logical reasoning and whenever I have a driver issue, I just use these steps and I always overcome the problem.

Best of luck! *Toast :toast:

 

BSOD issue after fixing another BSOD error

Hi Williams,

There are several reasons why BSOD occur, which has different resolution. To check for any corruption or the integrity of your computer's Windows, we suggest that you perform a
Check Disk by following these steps:

• Type cmd in the search bar.
• Right-click on the Command Prompt, then Run as administrator.
  
• Type chkdsk x: /r, the /r command will fix errors found on the disk.

Let us know if you need further assistance.