Windows 10: BSOD Loop when laptop unplugged

I am getting a BSOD loop, but curiously only when my laptop is unplugged. It works fine when plugged in, but goes straight to BSOD loop if you unplug it.
Yesterday the files on my C: drive weren't showing up. The green loading bar in top was slowly loading up, but nothing displayed. Files on the SD card and external hard drive were showing up fine. Turns out I was seriously low on storage, 250MB or so. I restarted and it went straight to BSOD. Which just looped and looped for about 30 mins. I gave up and turned it off. Which seemed to fix it, until I unplugged it to move and then got BSOD loop again. This happens now every time I try to run on battery power.

I hadn't installed any new programmes or deleted anything for a few days before the BSOD loop error.

I'm getting the following error:
system_thread_exception_not_handled
iaStorAC.sys

What I have tried so far:

• Uninstalled the minor windows update that was installed 16/06/2020
• BIOS update from Dell - November 2019
• Uninstalled Intel Rapid Start
• Uninstalled Intel Rapid Storage
• Freed up 40GB of hard disk space
• Tried a soft re-install of Windows whilst keeping my files. Which failed due to "an error".
• All drivers are up to date.
• Tried to run chkdsk on C: through command prompt, but this didn't work on restart.
• Run an error checking on the C: drive which seems to just stop after a while
• I have no idea how to access the SSD drive though, as it doesn't show up on my computer etc. I assume it's just running in the background with the windows install on it.
  
• I'm running:
  Dell XPS 15 9530 1TB hard drive and 250GB SSD - on which I believe windows is installed.
• Windows b4 bit with 1903 No May 2020 update yet for me
• No roll back option available

I would rather not have to do a full re-install of windows, but will do if necessary.


Any help is appreciated. Thanks.

:)

 

Windows 10 automatic repair fail loop

Hi,

We understand your concern and we will provide the assistance required to help resolve the issue.

I suggest that you perform Power Drain which will help you skip the reboot loop and help you access the PC. To perform Power Drain, refer to the steps below

• Unplug the charger and remove the battery of your laptop, if using a desktop remove the power cord.
• Press and hold the Power button for 30sec
• Plug the charger/power cord and restart system.

Hope this helps

Regards

 

BSOD Loop

I just unplug and plug again my LCD cable ...... after that its working well but after 5 to 10 min my system suddenly show BSOD (Stopcode : SYSTEM_THREAD_EXCEPTION_NOT_HANDLE) when my system restart after that the BSOD Loop Start .....

 

bsod loop device verifier ionmanager violation

Hi Tom,

To better assist you, provide the answers to the following questions:

• Have you made any changes on your device prior to the issue?
• What is the complete error message that you're seeing on the screen?

For the meantime, we suggest checking the answers on the following threads below which we found similar and helpful in resolving the issue:

Windows 10 Driver Verifier BSOD loop.. how to get out of it?

Windows 10 stuck in bsod reboot loop

Let us know if you need further assistance.