Windows 10: BSoD out of No reason!?!

My Windows shows the BSoD of System Tread Exception Not Handled and when I start it in Safe Mode it shows Critical Error Died. Before this when it was running smoothly l, I only did is that watching one punch man. But when I shut down my pc, it never gone started and automatically my safe mode also gives me a BSoD, now what to do.

:)

 

BSOD- atikmpag.sys

This is most likely due to an installation/upgrade error with ATI driver's. I suggest doing DriveSweeper and the following:

• Drivesweeper all drivers & in Safe Mode
• Unistall all drivers that aren't used in DriveSweeper (CCC Profiler Updates, MSI AfterBurner, anything related to ATI that use's it's drivers.)
• After you do this, the first thing you need to do is go into Device Manager and Unistall your ATI Drivers

Once your done, restart the PC and then try installing the latest drivers.


I had several issues with this in the past, but I overcame it with logical reasoning and whenever I have a driver issue, I just use these steps and I always overcome the problem.

Best of luck! *Toast :toast:

 

BSOD issue after fixing another BSOD error

Hi Williams,

There are several reasons why BSOD occur, which has different resolution. To check for any corruption or the integrity of your computer's Windows, we suggest that you perform a
Check Disk by following these steps:

• Type cmd in the search bar.
• Right-click on the Command Prompt, then Run as administrator.
  
• Type chkdsk x: /r, the /r command will fix errors found on the disk.

Let us know if you need further assistance.

 

Getting BSOD 0x124 error

Ignore what everone said here.

0x124 BSOD is usually related to VCCIO (VTT), run Prime95 version 26.6 with custom sizes of 512K to 640K with 50% of your memory for at least 8 hours.

If you get a 0x124 BSOD, increase VCCIO voltage by small steps, run Prime95 again until your stable.

If you pass Prime95 512K to 640K without a BSOD, then its Vcore too low. I'd suggest running IntelBurnTest with 80% of your memory to verify stability (8 to 12 hours).

Oh, and yeah, if this problem appeared all of the sudden, the reason is CPU degradation, you can prevent it by enabling C-States or adjust your overclock to use lower voltages.