Windows 10: Bsod problem with ssd

So I recently got a new ssd for my PC and when I installed it I was met with the BSOD on startup so thinking it may have been the new ssd I changed it back to the old one that was plugged in which it was previously running fine on 10 minutes prior and now I have the BSOD again and cannot properly boot the PC even tho it is the exact same as it was when it was running earlier.Any help would be greatly appreciated, Thanks.

:)

 

Z Book BSOD with Second SSD Drive

Hi all

I have an issue with an HP Z Book. It is a new Generation 6 device and came with a pre-installed second SSD drive.

All worked fine until I tried to put our corporate image onto the primary OS SSD.

Firstly, the new OS installed onto the secondary SSD rather than the primary.

So I disconnected/removed the secondary, recreated the partition on the primary and loaded our stock OS.

The machine now works absolutely fine, as long as I do not try to re-introduce the second SSD drive.

If I reinstall this, the machine boots up OK for a second or two and then BSOD's.

Can anyone suggest the reason for this issue - the BSOD message reported a kernel error.

Any ideas on steps to take to resolve this?

Thanks

Phil

 

BSOD- atikmpag.sys

This is most likely due to an installation/upgrade error with ATI driver's. I suggest doing DriveSweeper and the following:

• Drivesweeper all drivers & in Safe Mode
• Unistall all drivers that aren't used in DriveSweeper (CCC Profiler Updates, MSI AfterBurner, anything related to ATI that use's it's drivers.)
• After you do this, the first thing you need to do is go into Device Manager and Unistall your ATI Drivers

Once your done, restart the PC and then try installing the latest drivers.


I had several issues with this in the past, but I overcame it with logical reasoning and whenever I have a driver issue, I just use these steps and I always overcome the problem.

Best of luck! *Toast :toast:

 

Windows 10 1709 System Restore problems...

That seems to be an attempt at Option 2 in the tutorial, which requires you to
a. Boot to a command prompt (Did you?)
b. You then seem to be mixing steps 3,4 and 5, thus your command is incorrect.

I suggest Option 1 is easier.

If you still have problems, please repost listing each specific step and saying which option from the tutorial you are using. Thanks.