Windows 10: BSODs Even after doing a system reset

Hello,

For maybe around a month now, I have been having constant BSODs and attempting to fix it myself hasn't been very productive. Note: These BSODs only occur whenever I play a game, mainly Monster Hunter: World.

I've tried doing a windows restore using a flashdrive, and I also have used the "reset this PC" under the recovery options and chose to remove everything. I have also tried reinstalling my graphics driver. I ran memtest86 for 4 passes, I'll likely run it again for a longer duration. Using Crystal Disk Info, I found that there is exactly one raw value of current pending sector count and one raw value of uncorrectable sector count. Not sure if that is potentially related, but I included it anyways.

Before I reset the PC, the most common stop code was System_Thread_Exception_Not_Handled, and after reset the most common is KERNEL_SECURITY_CHECK_FAILURE. I am running Windows 10 1909 OS Build 18363.778. Any help would be greatly appreciated.

:)

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

AMD FX OC'ers Club

That's what the auto setting will do since you're over the 1333 mark it jumps to the next step which isn't listed or officially supported I assume by that ram.

At this point though I would suggest dropping the multi one step or .5 so that we can get something stable and possibly take the heat issue out of the picture for now.

 

BSOD- atikmpag.sys

This is most likely due to an installation/upgrade error with ATI driver's. I suggest doing DriveSweeper and the following:

• Drivesweeper all drivers & in Safe Mode
• Unistall all drivers that aren't used in DriveSweeper (CCC Profiler Updates, MSI AfterBurner, anything related to ATI that use's it's drivers.)
• After you do this, the first thing you need to do is go into Device Manager and Unistall your ATI Drivers

Once your done, restart the PC and then try installing the latest drivers.


I had several issues with this in the past, but I overcame it with logical reasoning and whenever I have a driver issue, I just use these steps and I always overcome the problem.

Best of luck! *Toast :toast: