Windows 10: Bypassing BitLocker, resetting PC

A user reset a new company laptop and inadvertently installed BitLocker, they don't have credentials to the account they used. We won't be able to recover it.We don't need anything on this device. In an effort to make it usable I tried running reset, and get There was a problem resetting your PC. I created installation media from another computer on a USB stick and when that installs I cannot find a drive to install it on. I tried Refresh and Load driver.We couldn't find any drives. To get a storage driver, click Load driver. Is there any easier way to resolve this? I am at the point where I

:)

 

bitlocker bypass

Hello, I have an TOPTON GAMING MINI PC that operates on Windows 10, and anytime I turn it on, it says "Recovery: there are no more Bitlocker recovery options on your PC, you'll need to use the recovery tools on your installation media" and if I press f9
it asks me to insert my BitLocker recovery key. The thing is, I don't have the recovery key nor do I have any access to it (I have the account I set up the computer with). I want to be able to use the computer again. Is there any way to reset it and get rid
of the Bitlocker recovery?

 

Need to turn off Bitlocker to install Windows 10

Hi,

We suggest doing the following steps again to resolve the issue. To complete the procedure, make sure that you have the following information:

• You must be able to provide administrative credentials.
• The drive must be BitLocker-protected.

To suspend BitLocker Drive Encryption on an operating system drive, please follow the steps below:

• Click Start, click Control Panel, click
  System and Security, and then click BitLocker Drive Encryption.
• Click Suspend Protection for the operating system drive.
• A message is displayed, informing you that your data will not be protected while BitLocker is suspended and asking if you want to suspend BitLocker Drive Encryption.
  
• Click Yes to continue and suspend BitLocker on the drive.

Let us know how it goes.

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".