Windows 10: Can i convert mbr to gpt with just deleting volume or diskpart clean is needed

Can i convert mbr to gpt with just deleting volume or diskpart clean is needed

:)

 

Cannot convert GPT to MBR.

Hi Michael,



I suggest you to follow the below steps and check if it helps.

This method you have to backup all your data and delete all partitions and volumes. Then use the
DISKPART command.

• Open command prompt and type in DISKPART and press Enter
• Then type in list disk (Note down the number of disk you want to convert to GPT)
• Then type in select disk number of disk
• Finally type in convert gpt.

Hope the information helps. Do reply if you need further assistance.

 

clone MBR HD to bootable GPT partition?

Hi,

1. You cannot convert mbr to gpt without data loss. otherwise, you can follow directions here:

FROM WINDOWS RECOVERY CONSOLE:

To change a master boot record disk into a GUID partition table disk using a command line

• 
  Back up or move the data on the basic master boot record (MBR) disk you want to convert into a GUID partition table (GPT) disk.
  
• 
  Open an elevated command prompt (right-click Command Prompt, and then click Run as Administrator) and type diskpart. If the disk does not contain any partitions or volumes, skip to step 6.
  
• 
  At the DISKPART prompt, type list disk. Make note of the disk number you want to convert.
  
• 
  At the DISKPART prompt, type select disk <disknumber>.
  
• 
  At the DISKPART prompt, type clean.
  

2. I'd suggest converting your vista drive to a virtual machine, load that up on your windows 10 system and use a program like virtualbox to run it.

 

convert MBR to GPT disk

convert mbr to gpt

There is a way to convert mbr to gpt without data loss. clean command deletes all datas inside the disk, so dont use this command

boot with windows dvd , and get into command prompt

type diskpart , find the disk number , which is need to convert mbr to gpt

say disk number is 0

exit diskpart

type below command in command prompt

mbr2gpt /convert /disk:0

wait for some minutes to complete , once you get commpleted successfuly means, exit and close ,

shutdown the pc , remove windows dvd

important

After the disk has been converted to GPT partition style, the firmware must be reconfigured to boot in UEFI mode.


Make sure that your device supports UEFI before attempting to convert the disk.