Windows 10: Can I interrupt disk fix? It’s taking hundreds of hours

My Win 10 PC was randomly shutting down and after booting to safe mode, I ran scan disk from within Windows not Cmd window., and opted to fix one of the drives, after the scan said there were “errors”.Now the PC was rebooted, and it’s fixing the disk. But it’s been going on for 2 days now! Currently it is F

:)

 

Disk management console view is not up-to-date

i dont know how to fix your disk management, but i can fix your partition problems...




open up Command Prompt with admin rights. (Right click, run as admin)


enter in
DISKPART
list disk

then find the Disk number for your Raid array... lets call it number 7 ( you can tell what disk is what by the total size)
type in

Select Disk 7
List Partition (will give you a list of all the partitions..)
Select Partition 1 (im assuming you only have 1 partition on Disk 7) repeat this step if you have more partitions.
ASSIGN


that should get the array up and running ready to use.


EDITED.

any problems, post back ^^


Still EDITING *Stick Out Tongue

side question, have you tried restarting the PC?

 

"Repairing disk errors. This might take over an hour to complete." loop for hours

• Hey Dave! I wish I could tell where it is in the process. All
  I see is a Lenovo logo screen
• with circling dots
  

• 
  transitioning between these three messages:

• 
  1) "Preparing Automatic Repair"
  
  2) "Repairing disk errors. This might take over an hour to complete."
  

• 
  3) "Diagnosing your PC"

• 
  It continuous in this cycle over and over with the screen turning black for a second before starting the loop
  again.
  
  
  
  

 

AMD FX OC'ers Club

That's what the auto setting will do since you're over the 1333 mark it jumps to the next step which isn't listed or officially supported I assume by that ram.

At this point though I would suggest dropping the multi one step or .5 so that we can get something stable and possibly take the heat issue out of the picture for now.