Windows 10: can I upgrade my all in one 1.0 gh processor and 4 bit and 1 terabyte system windows 8 to...

I have an Acer Aspire Z all in one its capabilites are 4 and a tarabyte. its has a 1.90 gh processor. it runs windows 8.1 can i jump immeidiately to windows 11.

:)

 

speed of processor 1 in group 0 is being limited by system firmware !?

I am seeing several messages in the event log shortly after I boot (the adapter message appears earlier than the processor messages):

• A command sent to the adapter has timed out. The adapter did not respond.
• The speed of processor 0 in group 0 is being limited by system firmware.
  The processor has been in this reduced performance state for 71 seconds since the last report.
• The speed of processor 1 in group 0 is being limited by system firmware.
  The processor has been in this reduced performance state for 71 seconds since the last report.
• The speed of processor 2 in group 0 is being limited by system firmware.
  The processor has been in this reduced performance state for 71 seconds since the last report.
• The speed of processor 3 in group 0 is being limited by system firmware.
  The processor has been in this reduced performance state for 71 seconds since the last report.

What could be causing this? My firmware is up-to-date.

 

System Reserved Partition on Disk 1 not Disk 0

The results were the same as before: Windows is installed in a single 477 GB partition on Disk 0 and the System Reserved is in a 500 MB partition on Drive 1. The rest of Drive 1 is unallocated. This is identical to the configuration I had when I asked the
question.

The Media Creation Tool used to created the install ISO DVD is v. 10.0.14393 downloaded on 12/13/2016.

I followed your instructions:

• I selected Drive 0 and deleted the existing Windows partition.
• I clicked New and Apply. Windows then formatted Drive 0 as a single primary partition.
• The existing System Reserved partition was still on Drive 1.
• So I deleted the System Reserved partition on Drive 1 and the just created Primary partition on Drive 0
• I then selected Drive 0 and clicked New and Apply again. Same result a single Primary partition on Drive 0. Drive 1 was left unallocated.
• Upon completion of the install
  • Windows occupies about 15 GB in the only partition on Drive 0
  • The 500 MB System Reserved partition was placed on Drive 1
  • The rest of Drive 1 is unallocated.

How can I get the System Reserved partition to be placed as the Partition 1 on Drive 0 with Windows installed in Partition 2?

Thanks.

Bill

 

switch disk numbers: I want Disk 0 to be Disk 1 and Disk 1 to be Disk 0

Hi, My computer contained a normal HDD hard drive. I recently upgraded to a SSD. The original HDD is Disk 0 and the new SSD is Disk 1. The windows OS is on Disk 1. I want to dual boot my system with Windows and Ubuntu with both OS being on the SSD. Since
the SSD is Disk 1 the Ubuntu install goes directly to Disk 0 because Disk 0 is first on the list. How can I switch the two Disks so my SSD drive is Disk 0? Thanks.