Windows 10: Can not run this driver from Windows update system : Dolby - SoftwareComponent - 3.30702.720.0

Can you please what is the reason that can not install this driver from the Windows update : Dolby - SoftwareComponent - 3.30702.720.0

:)

 

Unlocked Realtek HD Audio Drivers Windows 7 & 8 (With Dolby Digital Live and DTS Interactive)

Wait, but have you done the whole step-by-step guide described in the OP? DDL/DTS isn't supported natively by Windows 8/8.1 either, unless if you do the steps listed there.

 

The Ultimate Realtek HD Audio Driver Mod for Windows 10

Hi, i try to install the Realtek HD Audio + Sound BlasterX 720° 6.0.1.8328 MOD by Lynn (2018-02-06), i follow this step:
1- disinstall old driver
2-clean the registrer with the .reg file
3-restart
4-install realtek software, reboot and wait for the other part of installation
5- use the .reg "registro audio no firmado"
6- reboot
after this step the driver that windows see are the high definition audio from microsoft.
i would like to install the realtek mod driver with dolby atmos and dolby home theatre (or creative 720, depends on who offers more). Someone could share a complete guide?
I would like to point out that the pc is a hp dv6 laptop

 

The Ultimate Realtek HD Audio Driver Mod for Windows 10

For those who just need to enable Dolby Digital Live 5.1 for your realtek sound card here is complete manual. Works for me in Win 10 Creators update (1703). Easy installation if you do not need these Dolby things just allow DDL 5.1

Here is the post #27
https://www.techpowerup.com/forums/...by-digital-live-dts-interactive.228612/page-2
and here is the link for Realtek R2.80 driver doownload (can not be found on Realtek official site)
MEGA

You also need to enable Test mode before installation of the driver.

Enable Test mode:

Step 1. Open the Windows command promt as "Run as Administrator".

Step 2. Run "bcdedit -set loadoptions DDISABLE_INTEGRITY_CHECKS" (without the "").

Step 3. To finalize the process run "bcdedit -set TESTSIGNING ON" (without the "").

Step 4. Reboot and you're done.

To disable it do step 1 and run these commands on step 2 and 3:

Step 2. "bcdedit -set loadoptions ENABLE_INTEGRITY_CHECKS" (without the "")

Step 3. "bcdedit -set TESTSIGNING OFF" (without the "")

Then do step 4 and you're done.

Then you can continue to installation of the driver.

I hope I helped you, if any questions, ask here I'll try to answer you if I'll be able.