Windows 10: Can Ram install cause power on trouble?

At first I installed the new 8GB to my previously used 4GB slot. But it seems like it wasn't plugged properly, I turned the switch, display show nothing but fan spin. I swapped the ram in other slot but it didn't respond at all. So I removed CMOS and replug it and remove both ram. When I turned the switch, motherboard beep and fan spinned but didn't turned on. Now it isn't even beeping or fan spinning.

:)

 

AMD FX OC'ers Club

That's what the auto setting will do since you're over the 1333 mark it jumps to the next step which isn't listed or officially supported I assume by that ram.

At this point though I would suggest dropping the multi one step or .5 so that we can get something stable and possibly take the heat issue out of the picture for now.

 

To RAM or not to RAM...

Hey genesis what hardware have you bought, you might be able to save on the ram and step up the rest of the hardware a little...

Or you could go out on the town as suggested... *Big Grin

 

Internet connection causes computer to loose power.

Hello Cliff,



An outdated network adapter can be one possible reason for this.
To isolate the issue, kindly provide us these details:

• Have you made any changes on your computer prior to the issue?
• How are you connected to the internet? Is it via Ethernet cable or is it wirelessly connected?
• Have you installed the latest Windows updates?

To help us diagnose the cause of this error, we would suggest that you follow these steps:



Step 1: Boot into safe mode and check if the issue persists

Safe mode starts Windows with a minimal set of drivers and services. To boot into safe mode, kindly follow the steps on this link.



Step 2: If issue does not persist in safe mode, we suggest you to place the computer in clean boot and check which third party application driver is causing the issue.

Follow the steps on this link to
perform a clean boot.



Note: After troubleshooting, make sure to set the computer to start as usual as mentioned in Step 7 in the above KB article.



We’ll keep an eye out for your response.