Windows 10: Can Somebody Help Me With My WiFi?

Hi! So about a month back, the connection on my computer began growing increasingly unstable with the ping constantly spiking into the hundreds and even thousands. The thing is, it is only with this one computer, my girlfriend's laptop works just fine even in the same room with all of the same barriers between it and the router. I've tried several solutions I'll list them below, but none have worked and so I'm coming to y'all for help because I'm getting desperate, half of the time it's so bad that I can't even load youtube or even get a ping test website to load in order to test it.I've che

:)

 

help to remote connect

not sure how to use both programs u 2 suggested, i need more helpful steps thanks

 

Help! WiFi Problem

Hi Carmen,

Thank you for posting in Microsoft Community.

I suggest you to refer to the Microsoft help article and check if it helps.

Computer that has VPN software installed can't detect wireless network after upgrading to Windows 10

If the issue still persists, I would suggest you to run the flushdns which will
force the computer to clear the DNS cache and check if helps:

1. Press Windows key + r.

2. Type ipconfig /flushdns

3. Hit Enter

You can also follow the steps to reset Winsock. Then you can try release and renew IP address.

• 
  Press Windows + X and select command prompt(admin)
  
• 
  enter this command netsh winsock reset
  
• 
  restart the computer:
  

To release ip address and renew ip address you can try the following steps:

• Press Windows + X and select command prompt(admin)
• Enter this command ipconfig/ release thenhit Enter.

• 
  Enter this command to renew the ip address ipconfig / renew then hit Enter.
  

Hope it helps.

 

Can somebody help me on how to reconfigure boot loader in Windows 10?




Information First and foremost, you will need 2 thumbdrives or DVD's.
One for The Windows install media, and one for the Macrium Recovery Environment.
Also and External Disk for the system image will be needed.

When clean installing, you're really only looking to rebuild these two partitions:

1. ***Unplug ALL additional drives(internal as well as external before clean installing! Only have your system disk connected***
2. Boot into the Windows install media, and set up the language setting as always.
3. When it asks for a key, select "I don't have a product key" at the bottom.
4. Select custom install, and delete all partitions.
5. Select "Next" and let the installer build the partitions.
6. If the PC uses wifi you can also skip this step, as you will be re imaging your C: drive with all Windows updates, your programs, drivers, and data.
7. Go ahead and use Express settings because of the above also.
8. Let the install finish.
9. When you come to the desktop, go ahead and safely remove the install media.
10. Now shutdown and plug in the Macrium recovery media and boot into it.
11. Turn on the external device that contains the system image.
12. Click the Restore tab.

Find your image you made click on it, to select the partition(C and ONLY select this one.



Let Macrium restore the partition.
Close Macrium and reboot into Windows.