Windows 10: Can someone please give step by step process of how to change sequence of m 2 ssd and hdd...

HiI actually am updating my laptop with a new m 2 ssd and would like to know step by step process of changing settings in bios.I have been searching a lot but can't understand the management of bios settings in LENOVO LAPTOP.Pls if someone can help ......In how to change sequence

:)

 

PC Build Steps

Ok just because I like steps i am going to create some steps. Please give me the stamp of approval/disapproval

• Install system in case
  • Remember to connect SSD and optical to same SATA ports on motherboard
• Turn on PC
• setup HDD
• run blend test in prime95 for 30-60 min
  • run realtemp at the same time

• While in Prime95 test
  • if CPU goes above 70c in RealTemp, I have a leaky CPU
  • if my system locks up or blue screens, there is an instability in the system somewhere
  • if my system does not lock up or blue screen, my CPU is not damaged and I am in the clear!

What do you guys think??

 

PC Build Steps

1.1 - Ideally put optical in SATA 0, and SSD in SATA 1, this will cause the optical drive to be the default 1st boot option. You can change it manually if not, but I like it this way
2.infinity - yes, that's fine. if it's above 70 +/- 5 degrees, then it may just need a repaste/remount

 

x800 GTO 16 pipe unlock step by step

Ok, there is a gigantic thread going on with this that has been extremely helpful. However, you have to search the entire thread to actually figure out what to do. So, I'm going to list step by step instructions right here for anyone who needs them.



Step 1: Download the attachment
Step 2: Follow the instructions about checking your fuses
Step 3: Dump your bios with ATItool (Settings -> Miscellaneous -> dump bios)
Step 4: Open your current BIOS with RaBit 1.7 or later and go to "Logging" section scroll down and search for:
Desc: RADEON X800 GTO
Info: 11X-CC6600SA-004, CC6600SA.004, 01/20/05,14:19:32
Step 5: If all checks out, simply burn the iso, boot from it, and flash!

Ultra special thanks to dolf for coming up with all this stuff and thanks to everyone else in the forum. This should simplify the process a bit!