Windows 10: Cannot boot into my pc

Hello everyone. So basically couple of days ago my PC started freezing in some applications and games, as well as rebooting itself on random occasions. Yesterday after a reboot it would not load and instead showed a BSoD with an error “bad system config info”. Then I went to get into cause it wouldnt let me load it in a safe mode. In cmd I used the programs to reset the numproc and truncatememory to defaluts and after it, the error changed to “CRITICAL PROCESS DIED”, I suspect that the problem is in my hard drive cause I can use my PC if I load into UBUNTU for work purposes. I am unable to start windows, I tried hard reset and it shows an error, I tried running sfc scannow but it wont let me. I tried running chkdsk with different parameters and in the end it shows me an error 6. I created a bootable flash drive and when I insert it the image gets stuck at the MB manufacturer logo. Pls help.

:)

 

Boot Process

Hi,

Please suggest me a link that can explain the boot process step by step of ...

• Windows 7,
• Windows 8.1,
• Windows 10,
• Windows Server 2008 R2 and
• Windows Server 2012 R2

With Regards

InTech

 

PC wont boot up (No POST, No Video)

I recently installed a new Asus M5A99X Evo r2.0. The motherboard green LED lights up and the case and cpu fans spin. But there is no video when its hooked up to my monitor.

Steps that i have tried:
"No POST", "system won't boot", and "no video output" troubleshooting checklist

Made sure all connections are properly connected.

Flashing the CMOS

Tested the PSU

Followed all steps in the user manual

If there are any links that you guys can point me to or suggestions that could help it would be highly appreciated. Thank you

 

laptop doesnt boot automatically

This is what happened.

1. Did a repair install and later disabled hibertnate in CMD.
2. Enabled legacy option ROM in BIOS.
3. After a few times startup ( i used the system in such mode for 5 days), changed boot option back to default.
4. Vola!! It boots automatically to win10 without any keypress. Tested it with many starts to confirm the same.
5. Re-enabled hibernate option using CMD and later selected Fast Startup.
6. System booted normally, without the need for any keypress.

I do not know exactly whether such steps resolved the problem or what else happened, hence cannot suggest above steps.

Many thanks to all members who helped to troubleshoot problems.