Windows 10: Cannot connect to 2.4ghz wifi

I have tried every fix that is easily found on the internet. All command line suggestions, trouble shooter is a joke. I have reinstalled adapters more times than I can count. I have even done a clean install. At one point my system was setup as a dual boot, the issue started then. Tests on the network card indicate it is fine. The problem seems connected to the network adapter searching for the network channel. Instead of searching the normal range, 1-11 in North America; it searches a range of 100k's. I've reset settings everything. I cant even roll back, because the clean install made a blan

:)

 

Windows 10 - WIFI 2 - Cant connect

Hi
Myamara,

It is possible that your drivers are outdated or the connection itself has the issue. We suggest that you perform
these methods of troubleshooting
and check if there are any changes:

Method 1: Reset TCP/IP

To do this, follow these steps:

• 
  Run
  Command Prompt
  as
  Administrator.
  
• 
  Run
  this command:
  
  • 
    netsh int ip reset
    and hit
    Enter.
    

Exit
Command Prompt
and
monitor your WiFi connection.

Method 2: Disable auto turn-off of WiFi device.

Go to
Network and Sharing Center. At the
right pane, click
Change adapter settings.
Right-click
on your
connection name(WiFi name)
and go to
Properties.Click
the
"Configure..."
button and go to
Power Management
tab.Uncheck/disable
the
radio button
for
"Allow this device to turn off this device to save power". And then,
Restart the PC(Important).

Method 3: Reconfigure TCP/IP

To do this, follow these steps:

• 
  Run
  Command Prompt
  as
  Administrator.
  
• 
  Run
  these following commands:
  
  • 
    netsh int tcp set heuristics
    disabled
    
  • 
    netsh int tcp
    set global autotuninglevel=disabled
    
  • 
    netsh int tcp set global
    rss=enabled
    

Update us on how it goes.

Regards.

 

When will the wifi connectivity problems be solved?


OK, so the Windows 10 engineers bollixed up the wifi connectivity part of the operating system. Everybody knows that by now. It seems they are making some progress in resolving it. Now, instead of seeing "Secured, No Internet" on your list of wifi connections, you see "Connected, Secured" EXCEPT no webpages will load. So you really aren't connected. It does seem to be a step in the right direction. Does anybody know when they plan on a full and complete repair of this screw up of epic proportions?

 

help to remote connect

not sure how to use both programs u 2 suggested, i need more helpful steps thanks