Windows 10: Cannot enable BitLocker as drive contains system boot information

I try to enable BitLocker on my system drive "C:" but got following error. How to resolve it? Thanks, have a nice day.I have multiple SSD, the Volume 2 contains bootloader, the Volume 3,4 is the C: drive.

:)

 

Windows 10 Bitlocker will not enable on system drive (But will on other drives)

Hi,

Thank you for the update and I apologize for the delay in response.

I would like to inform you that as BitLocker requires memory to encrypt, I would suggest you to check if there is sufficient space in the drive.

I suggest you to disable BitLocker from other drives and then try enabling BitLocker on the system drive followed by other drives.

Let us know if you need further assistance. We will be happy to help.

Thank you.

 

BitLocker won't enable on Windows 10 after update on Aug 9

Hi Brenda,

I would be happy to assist you.

Before I assist you I would like to know the information below,

• 
  Do you have a Windows 10 copy of the operating system?
  

I suggest you check whether the Bit locker is ON or OFF using the steps below.

Can you verify if BitLocker is enabled or disabled on your device? You can Enable/disable BitLocker by going to Desktop and follow these steps:

• 
  Swipe Right to Left to bring up the Charm.
  
• 
  Choose Settings.
  
• 
  Choose Control Panel.
  
• 
  Select BitLocker Drive Encryption.
  
• 
  Verify whether BitLocker is on or off on each device.
  

Also I suggest you to enable the WinRE so that you can enter the bit locker key and proceed.

When WinRE is disabled, you cannot enable BitLocker, and you receive an error message that resembles the following.

This PC doesn't support entering a BitLocker recovery password during startup. Ask your administrator to configure Windows Recovery Environment so that you can use BitLocker.

The solution would be to manually enable the windows recovery environment:

• 
  Copying the winre.wim file from c:\windows\system32\recovery\ to a folder on a recovery partition. (The partition need to have a drive letter at this point.)
  
• 
  Set the RE Image path. Example: reagentc /setreimage /path r:\recovery\windowsre
  
• 
  Enable RE with command: reagentc /enable
  
• 
  (You may remove the drive letter for the recovery partition after you have done this.)
  
• 
  Bit locker will be enabled.
  

If the issue still persists, suggest you to post your query on the below link.

https://technet.microsoft.com/en-us/library/hh831507(v=ws.11).aspx

Hope this information was helpful and do let us know if you need further assistance. We will be glad to assist.

Thank you.

 

Need to turn off Bitlocker to install Windows 10

Hi,

We suggest doing the following steps again to resolve the issue. To complete the procedure, make sure that you have the following information:

• You must be able to provide administrative credentials.
• The drive must be BitLocker-protected.

To suspend BitLocker Drive Encryption on an operating system drive, please follow the steps below:

• Click Start, click Control Panel, click
  System and Security, and then click BitLocker Drive Encryption.
• Click Suspend Protection for the operating system drive.
• A message is displayed, informing you that your data will not be protected while BitLocker is suspended and asking if you want to suspend BitLocker Drive Encryption.
  
• Click Yes to continue and suspend BitLocker on the drive.

Let us know how it goes.