Windows 10: Cannot find PCIe 4.0 NVMe M.2 SSD during Windows 11 installation but found in BIOS

I'm trying to install Windows 11 on my new PC.Hardware:CPU: AMD Ryzen 5 5600Motherboard: ASUS TUF GAMING B550-PLUSSSD: Kingston FURY Renegade PCIe 4.0 NVMe M.2 SSD installed on M.2_1 slot, supports PCIe 4.0 x4 & SATA modesWindows ISOownloaded from https://www.microsoft.com/software-download/windows11 latest; made a bootable USB 3.0 disk.I updated the BIOS; installed Linux on it and it works without a problem, so it could not be a hardware issue.I'm not sure if it's the BIOS configuration that is not correct or simply the driver support for this SSD is just missing from the Windo

:)

 

Clone present nvme pcie ssd to replacement nvme pcie ssd?

I have a 500GB M.2 2280 NVMe PCIe SSD (boot drive) that I want to replace with a higher capacity M.2 card.

Where do I put the new SSD during the NVMe to NVMe cloning process? My mobo only has one M.2 slot for NVMe SSD's so do I want to use an external adapter for one of the M.2 cards? If so, do you have a recommendation?

If you have solved this issue for your desktop or laptop I would like your advice on if and what extra hardware you needed during the cloning.

please remember that I am dealing with PCIe NVMe drives ONLY. NO Sata is involved except possibly for a connecting cable from the desktop to an adapter. I am experienced with cloning SATA III drives but cloning NVMe is a little
new to me.

Computer: Dell XPS 8920, 32GB ram.

Present SSD: KXG50ZNV512G NVMe Toshiba 512GB

New SSD: CT13049074 Crucial P1 NVMe PCIe M.2 SSD 1TB (or 2TB if available soon) or similar storage device.

Windows 10 Pro for Workstations, version 1809.

 

Windows not recognizing new m.2 NVME SSD but shows in BIOS

I purchased a crucial nvme m.2 ssd for my MSI GT73 Titan - It shows in the PCIE section of the BIOS but does not show in disk management - Also does not show up in Crucial's Storage Executive Application.

My BIOS is the latest version.

Any ideas?

 

Migrating Windows 10 from m.2 sata to new pcie nvme ssd

Hello all,

I'm going to upgrade my current m.2 sata 128gb to a m.2 pcie nvme 480gb and have questions about migrating Windows over. From my understanding since i have a laptop and cant connect both drives at the same time and pcie nvme isnt supported externally I was
going to try and create a restore disk of my current drive and then image it to my new drive. Will this work?

Again my process will be, create rescue disk and image to usb, power down and swap drives, enable usb boot to my usb and power on, run the rescue disk and image to my new pcie nvme ssd.

Does anyone see problems with this? Do I need a large usb or will 32gb work for a 128gb ssd?