Windows 10: Can't access some parts of settings on my own PC?

So I recently factory reset my PC after having a few issues. However when I just tried to do a health check, I cannot open Windows Security...It says to to contact IT helpdesk but this is my personal PC at home and there are no other accounts on it except me. I looked it up and it said to remove the Microsoft admin account but I don't have one. Again, its only me. So any help would be appreciated as I don't really know what is happening. windows 11

:)

 

AMD FX OC'ers Club

That's what the auto setting will do since you're over the 1333 mark it jumps to the next step which isn't listed or officially supported I assume by that ram.

At this point though I would suggest dropping the multi one step or .5 so that we can get something stable and possibly take the heat issue out of the picture for now.

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

access BIOS settings in Win 10

I have an 8-year old computer running Win 10. I need to access the BIOS settings. It used to be the holding down the F2 key during startup would bring up the BIOS screen in Windows computers. But this no longer works. A web article listed a complicated
series of steps leading to a reboot . . . but still no access to BIOS. Any suggestions?