Windows 10: Can't access the WIndows Security Center

I have a notification in my system tray to check the sucurity center but it just goes to a black and gives me a message about the IT Admin, Any help or insight would be appreciated.

:)

 

Windows keeps turning off the security center.

Hi Maninder,

I suggest you to follow the steps below and check if it helps.

• Press Windows key + R and type Services.msc then hit enter.
• Services Console will appear.
• Find Security Center Service on the right details pane > right click it choose properties >
• Security Center Properties should appear > on the General Tab

set start-up type to automatic (Delayed start)

• On service Status Stop and then Start.

If this does not works & error still continues then there are more chances that your system is infected

Let us know the status of the issue in regards with Security Center. Your reply is important to assist you further.

Regards,

Guru Kiran

 

windows defender & security center services keep turning off


Are you running any other AV or did you have one running in the past? If you didn't use an uninstaller for the AV, then the remnants of it could be causing the problem. Normally any time you install an AV it disables Defender by default.

If you are getting any error codes please list those, that will be helpful in helping you.

As torre suggested, might be a good idea to do a reset or even a reinstall.

Reset Windows 10 - Windows 10 Forums

Windows 10 - Clean Install - Windows 10 Forums

There are also some suggestions listed here:

Unable to turn on Windows Defender in Windows 7 / 8 / 10

 

Windows 10 Security Center Service can't be started

I am also having a probem starting windows security center. When I did the following step: I found the following disabled:

Security center properties

Windows update properties

Security center WSCSV

Remote registry

net.tcp port sharing

internet connection sharing

COMODO LPS launcher

COMODO Internet security

Auto time zone update

Should these be enabled and if so how do I enable them?

I have no defense toward any threats at this time. Please help!!

Method 1: I suggest you to follow the steps provided below:

• Press Windows key + R on the keyboard.
• Type “Services.msc” without quotes and press Enter.
• Locate for Remote Procedure Call (RPC) and Windows Management Instrumentation.
• Check whether the following services are Started and set to Automatic.