Windows 10: can't calibrate in game controller

Hi, i have a saitek x52, and am trying to calibrate it, but when i look in the game controller menu i don't see a settings tab. so i can't calibrate the stick. i have tried to calibrate it in the software that comes with the driver of it, but there i can't calibrate it, and in the games i play i can't calibrate it, sonote: i can't upload a screenshot because it fails everytime i want to upload itmy system: windows 11prosessor: ryzen 5 4500graphics card: gtx 1660 super 6gbram: 16gb

:)

 

controller calibration

Hello Amir,

I am Jaspreet Singh.

The calibration settings will be different for different controllers.

Follow the steps listed on the screen for this one.

 

BU0836X game controller won't calibrate

After updating from Windows 10 home to Windows 10 pro my BU0836X game controller cannot be calibrated. It shows up in the list of game controllers but when you click on properties to try and calibrate the device the box says it's a communications device
and calibrate is grayed out. Furthermore, this device worked fine before I updated to windows 10 pro!! I need this device as part of an experiment I've been working on for the last 5 years and I do not have time for this nonsense. I tried every single "fix"
I could find not one worked at all. I paid for the updated OS thinking it would be an improvement. Instead it set me back months. What is the problem and how can I fix this?

 

Controller Calibration Wizard is BROKEN

Hello--

I need some help. I don't get along with computers and am just a step or two above tech-illiterate so please allow for my idiocy. Apologies in advance if I come off as a bit peeved; I've been mucking about with my controller and computer for almost three hours now.

My hard/software: Windows 10, Project64 emulator, retrobit 64 tribute controller (single joystick, essentially the old N64 controller).

Not the problem: My controller is showing up under devices like it should. It interacts with the emulator just fine, except for calibration being absolutely necessary. I can access and run the calibration wizard.

The Problem: When I run the calibration wizard, it never goes through the steps where I calibrate the X and Y axes. It jumps straight to the Z axis, which I don't have and it does not register whatsoever. I just need to calibrate my single joystick, but the calibration wizard on my computer does not provide the proper steps to do so.

With my luck I won't be surprised if this is a never-before-encountered, one-in-a-million chance, unfixable problem. But please, please tell me that it's a simple fix and that I am just an idiot. Thanks in advance, folks.

Here's Hoping,
Belle