Windows 10: CAN'T CONNECT TO WARZONE 2 via ROUTER BUT CAN WITH OTHER MEANS, HOW TO FIX?

IF YOU CAN FIX THIS YOU MAY BE A NETWORKING GENIUS I'm posting this to multiple forums maybe I get a solution. The game doesn't really matter maybe it does? but my problem is simple: I get "Lost connection to Host timed out" error when I want to play this game via my router and my home internet. The game works fine if I: - use a VPN - share a mobile hotspot - directly connect my home UTP cable to the pc and set up a PPPoE However it doesnt work if I connect my home UTP to router, set up the PPPoE and connect my pc to the router. Also it doesn't work on my Xbox Series X, I have the same pr

:)

 

wireless conection to router

Hi,

To better assist you, we would like to know the following information:

• Are you able to see the router's name in the wireless networks list?
• Are you able to connect to the router but unable to connect to the Internet?
• Do you receive any error message when connecting to the router? If yes, what is the exact error message that you receive?

In the meantime, we suggest that you run the Network troubleshooter. The Network troubleshooter can help diagnose and fix common connection problems. Kindly follow the steps below:

• In the search box on the taskbar, type Network troubleshooter, and then select
  Identify and repair network problems from the list of results.
• Follow the steps in the troubleshooter and see if that fixes the problem.

If the issue persists, kindly try the troubleshooting steps on the following link:

Fix network connection issues in Windows 10.

We recommend that you try the steps on the Update the network adapter driver,
Run the Network troubleshooter followed by networking commands,
Temporarily turn off firewalls and Use network reset to reinstall network devices sections.

Let us know how it goes for us to assist you further.

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

2 x SSD Raid 0 - is this right?

T ski b4 your done with this post can you list a step by step fix of what you did, I would appreciate it if you would...Thanks