Windows 10: Can't discovery devices over the different VLANs

So basically I've set 3 VLANs, where 2 VLANs are wired and the last is for Wireless.I've set my server and NAS on one wired VLAN and my main computer on another wired VLAN.I can't discover my server through SMB or computer computer in the VLANs. Any suggestion? No ACL rule yet.

:)

 

VLAN problems on managed Cisco switch.

So, I'm having a weird issue with a Cisco switch. I am using Aerohive APs and they use different SSIDs that communicate over several VLANS. For some reason, they are only able to communicate over one SSID on one VLAN. It doesn't even recognize the others. It appears as though the ports on the switch are setup the same as other switches that also have those VLANS/APs. Has anyone else experienced this?

Here is an example of the configuration of an AP port:

switchport mode trunk
switchport trunk allowed vlan (lists VLANs allowed here)
switchport trunk native vlan (VLAN number here)

The VLANs themselves are also configured on the switch along with the helper IP addresses that correspond to them.

The switch is using VTP version 2 with the correct domain listed. The switch is showing that it was configured by the correct VTP server, but not since March.

Model: WS-C2960S-24PS-L

Anyone have any thoughts?

 

Cannot keep Network Discovery Enabled.

Hi,

Thank you for the response.

I would suggest that you change the settings in the Firewall to allow Network discovery so that the Firewall stays On while allowing the Network discovery to be enabled.

Follow the steps.

a . Open Control panel.

b. Small icons from the drop down.

c. Click on Windows Firewall.

d. Click on Allow programs or feature through Firewall.

e. Scroll the list and check Network Discovery.

If you need additional assistance then let us know.

 

How can I change the VLAN id my device is using?

I'm trying to set up a tagged vlan (vlan id = 100) with 2 notebooks and a TP-LINK TL-SG105E switch connecting them. The first notebook (Dell) is running windows 7 and has Realtek ethernet adapter, therefore it was easy to tell it to use VLAN ID 100 in the
Realtek ethernet diagnostic utility. But the other notebook (Lenovo x230) running windows 10 has an Intel 82579LM Gigabit Ethernet adapter and has no option to set VLAN ID at all. Not even with Intel PROSet adapter configuration utlility. I've tried to set
the vlan id in powershell on the lenovo device with "set-netadapter -name "adaptername" -vlanid 100" but it requested operation not supported on the adapter. I set the ip addresses of the two devices and the switch to the same subnet. Still nothing.

Also set up the vlan in the switch before doing anything else. Created vlan with id 100 and set all the ports (not using the switch to anything else so it can use all the port for this job) as tagged to this new vlan 100. Also set PVID for all the ports
to 100 (tried without it first but didn't work either).

Both devices can ping the switch on it's ip address but the can't ping each other at all (Destination host unreachable). All my drivers are up to date.

Do you have any suggestions?