Windows 10: Can't go to advanced startup

I've been trying to go to my bios menu to enable secure boot and tpm or tmp 2.0 but I get no signal of my computer from my monitor but the pc is still on. I've tried to reset it many ways by holding f2, holding shift. del, and even from the settings where you just click it and you should be right on it but still nothing hapens. What should I do?

:)

 

Can't get GPU-Z to start with Windows 8.1 startup

I'm not sure how to do that. Could you list the steps for a noob?

 

Startup programs not launching on startup

Replying to Brink none of that works here is why-
Step 1- No items listed in startup on task manager as stated.
Step 2- I dont have shell:Startup on the pc as it cannot be located
Step 3- I dont understand that option also the startup folder cannot be found
Step 4- No apps showing under startup on settings
Step 5- Dont have access to advanced options at all for any apps
Step 6- Doesn't work.

Thanks for trying

- - - Updated - - -
@dalchina, Will try the program now and no I have no suitable restore points and also nothing that I am aware of has been updated besides for Windows Updates but nothing major. WIll respond once I try the program.

 

windows 10 no advanced-startup-options, so no startup settings

when i did 1. 2. 3. steps i checked and problem was SOLVED
but after 4. 5. 6. 7. steps i checked and no advanced startup options again

1. Make a complete backup image of your current HD including all partitions to an external HD using macrium reflect . Once done, disconnect all USB devices from the PC. Assuming now you only have one HD connected to the PC which you will be installing Windows.
   IMPORTANT: Also create a Macrium Rescue disk to boot from later on.
2. Boot up your Windows installation USB/DVD. On the first screen, Hold SHIFT + F10 to open Command Windows then type:
   Diskpart
   select disk 0
   clean
   exit
3. Click Next, Choose Custom, select the unallocated partition then click Next (Do not format), when asked for Product ID key, click on "Skip this step"/"Do it later". Continue the Installation.
4. Once done. With the external HD connected, Reboot your PC with the Macrium Rescue disk, select the image that you created in step 1 as the Source.
5. Select your current HD/SSD as Destination disk
6. Restore only C: Drive to it. ie. overwrite the new C: Drive with your backup C: Drive.
   NOTE: See screen shot on how to perform this step
7. Disconnect all the external devices. Reboot. Windows should perform a startup repair.

till 4. step there was no windows 10 key activeted and problem vas solved
but after step 7 i checked key and it was not the same which i purchased, why did that change? i activated purchased key again.
so is the problem to be a windows 10 key on my pc?
or do some drivers prevent advancedstartup options?