Windows 10: Can't load brand new M.2 with New Windows 10 Installed, boot device not found error

So long story short my original NVMe M2 was corrupted so I purchased a brand new NVMe M2 and I wanted to install Windows on it via USB method.I took out my old M2 and installed the new M2 in my motherboard, plugged in the Windows USB and proceeded to install Windows on it.At first I got an error message when I was trying to install saying "Setup was unable to create a new system partition" so i followed the guide here to resolve this error.https://www.youtube.com/watch?v=o4ilMAAk1Q8Then after that I restarted it just showed me my BIOS right away and I noticed that the new M2 I installed was no

:)

 

Installing Windows 11 on a new M.2 device.

Hi everyone, I hope yall are well.

I recently ordered a new M.2 drive for my PC as the current one is becoming dysfunctional and causes a lot of system crashes.

My question is how do you install Windows 11 on the new M.2 device that has no files on it after installing it into my PC?

I'm simply going to replace the M.2 with the old one in my computer.

I also have a valid Windows 11 key!

Any help would be gratefully appreciated!

Thank you!

Steven

 

Installing Windows 10 on New PC?

I'm going to be building a new PC on Christmas and want to install Windows 10 on it. I have Windows 10 on my current PC, which I installed upgrading from 8.1 with the files on a USB. How do I go about installing a clean copy of Windows 10 on this new PC? I think I recall something about installing it once makes Microsoft recognize your hardware, but since this will be a PC I'm not sure what steps I need to take. Do I need to go 8.1 -> 10 or is there a method of going directly to 10?

 

0xc0000098 On new M.2 SSD

Ive been trying, (unsuccessfully) to install a usb copy of windows 10 onto my new 1tb m.2 ssd.

So far i have tried just about every boot option my bios has and i cant get the program to load.

when i boot up my other drive that currently has a working copy of windows the usb and program seem to load fine. But the m.2 drive is the only one connected when i try to boot the program

So i am just unsure if i am missing something when it come to the m.2 interface or if there something else i am doing wrong.

specs: asus rampage v edition 10: i75860k:32gbram