Windows 10: Change router password.

I want to change my password on my internet connection. I can access the router in a web browser. How do I change it on a windows 10 PC?

:)

 

Trouble Changing Wi-Fi Password


I've been following the following steps to change my Wi-Fi password for some time:

1. Launch Control Panel.
2. Click "Network and Internet."
3. Click "Network and Sharing Center."
4. Click "Wi-Fi...."
5. Click "Wireless Properties."
6. Click the Security tab.
7. Check "Show characters."
8. Enter the password in "Network security key."

Those steps have been working just fine, but today I discovered a new wrinkle. If I change the password inside the router first, "Wi-Fi..." doesn't appear in step 4. This isn't much of a problem at home, because I can just change the password in Control Panel before I change it inside the router, but it would be a problem at a public hotspot, or something of that nature. I also tested Brink's instructions in "How to Connect To a Wireless Network in Windows 10," but they don't work for me either. How can I fix this?

 

Safely Changing Router Password

HI Sherry,

You should still be able to manage your router's password even with the prompt for the site not being secure. Though if you are unable to completely access your router's gateway, you can use the router's IP.

To get the IP, follow the following steps.

• Press Windows key and X.
• Select Command Prompt.
• Type: ipconfig /all.
• On the information that will show, look for DHCP Server, take note of its IP.

You can type the IP to your browser to access your router's gateway.

If you are still having concerns with accessing your router's gateway, best to contact your internet service provider if they are the ones who gave the router, or the router's manufacturer for further assistance.

Regards.

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".