Windows 10: Cisco Connection and 2 Networks

Hi. I have 2 Networks on my pc. both of them are VDSL. when i try to connect to "Any Connect Cisco" one the networks get blocked and only the first one works.what i want is to connect Cisco on network 1 while network 2 is still available to use. i can't use any other vpn protocol. cause my ISP blocked them

:)

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

network list service trouble with cisco vpn client

i have a workstation with windows 10 v 2009. I installed the cisco vpn client on this workstations. When i try that connecting on my cisco Remote access VPN server my the cisco vpn client connection broked. I tested with disabled the network list service and the cisco vpn client connection works ok. i tryed that change netprofmsvc.dll from version 1809 but the problem is the same. what i do?

 

Losing network connection

Hello Dear, if you have a laptop or a PC with a wireless network adapter, you can see a list of available wireless networks and then connect to one of those networks. The wireless networks will only appear if your PC has a wireless network adapter installed, the adapter is turned on, and the wireless access point is in range.

1. Click Start, click Control Panel, click Network and Internet Connections, and then click Network Connections.

2. In the left pane, under Network Tasks, click View available wireless networks.
In case, If you don't see the network you want to connect to, click Refresh network list. If you see the network but the signal is weak, move the PC closer to the wireless router.

3. Click the network you want to connect to, and then click Connect.

4. If you're connecting to a secure network, type the security key, and then click OK.

I Hope you solve out your query soon.