Windows 10: cmd opening after boot and writes the following....... as in image

after my system turns on this following cmd page opens anyone pplease help me how to fix this .........

:)

 

How To Format A Write Protected Flash Memory ?

¿You already tried this one?...

Run CMD


1. diskpart
2. list disk

Then in the 3º step, put the correct number of disk in the list for the usb flash (if it's listed in disk 3, then you'll have to write select disk 3).

2. select disk #
3. clean
4. create partition primary
5. select partition 1
6. active
7. format fs=fat32
8. assign
9. exit

with that commands you will format the flash drive in fat32, if you have a large drive you can select also "format fs=ntfs" in step 7.

good luck!

 

windows 100 app store wont open

Hi Craig,



I would suggest you to follow these steps and check if it helps:

Open an Administrator CMD window. If you can’t find a way, use these steps:

• Press CTRL+Shift+ESC to open Task Manager.
• Click File > Run New Task
• Make sure you have a check mark beside “Create this task with administrative privileges”
  
• Type CMD
• Type the following commands at the CMD prompt:
  
  dism /online /cleanup-image /restorehealth
  
  sfc /scannnow

Let us know the results.

 

laptop doesnt boot automatically

This is what happened.

1. Did a repair install and later disabled hibertnate in CMD.
2. Enabled legacy option ROM in BIOS.
3. After a few times startup ( i used the system in such mode for 5 days), changed boot option back to default.
4. Vola!! It boots automatically to win10 without any keypress. Tested it with many starts to confirm the same.
5. Re-enabled hibernate option using CMD and later selected Fast Startup.
6. System booted normally, without the need for any keypress.

I do not know exactly whether such steps resolved the problem or what else happened, hence cannot suggest above steps.

Many thanks to all members who helped to troubleshoot problems.