Windows 10: cmd using so much memory

Windows cmd takes about 2GB of ram when i open my pc. why is it doing that?

:)

 

Overclocking / Undervolting guide for Vega 56 or 64?

Here's a quick laundry list:

List of software to use for overclocking and testing
Examples:
Wattman (and how to find and use it, like an overview, including profiles)
Unigine Valley or Heaven (use this for quick testing while changing settings in Wattman and checking for stability / artifacts) ...just suggesting this
How to monitor cores / mem speeds and temps during testing (I've seen screen overlays, and others using GPUz)

Step-by step overclocking in Wattman
Fan speeds
Power limit
Temp limit
Voltages
Core speeds
Memory speeds

 

How To Format A Write Protected Flash Memory ?

¿You already tried this one?...

Run CMD


1. diskpart
2. list disk

Then in the 3º step, put the correct number of disk in the list for the usb flash (if it's listed in disk 3, then you'll have to write select disk 3).

2. select disk #
3. clean
4. create partition primary
5. select partition 1
6. active
7. format fs=fat32
8. assign
9. exit

with that commands you will format the flash drive in fat32, if you have a large drive you can select also "format fs=ntfs" in step 7.

good luck!

 

Memory issues

Thank you for updating us. We suggest that you run the Memory Diagnostics Tool, this is to check your system for memory problems. Follow the steps below:

• Open Control Panel and type memory in the search bar.
• Click on Diagnose computer memory problems to open it.
• If you're prompted for an administrator password or confirmation, type the password or provide confirmation.
  

Let us know the status of the issue.