Windows 10: Com port settings

I’m trying to change the com number for a usb serial device. When I click properties on the desired usb port there is no tab for ports configuration. How do I change com numbers? Windows 10 version 22h2

:)

 

AMD FX OC'ers Club

That's what the auto setting will do since you're over the 1333 mark it jumps to the next step which isn't listed or officially supported I assume by that ram.

At this point though I would suggest dropping the multi one step or .5 so that we can get something stable and possibly take the heat issue out of the picture for now.

 

Changing the Port settings for Serial-USB.

Hi,



Thank you for writing to Microsoft Community Forums.

If you want to change the port settings, please follow the steps mentioned below:

1. Open Device manager (right click on start button
   and then on Device manager).
   
2. Then expand port (COMS & LPT).
   
3. Then right click on Prolific USB-to Serial Comm Port and then on properties.
   
4. Go to port settings and click on Advanced.
   
5. You will be able to make the changes on this screen.
   

Hope this helps.

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".