Windows 10: Computer beeps and changes CSM to UEFI.

Hi, I have a very big problem and I need help please. I formatted my computer and now I have windows 10 and I would like to upgrade to windows 11 but I need to have secure boot set. Secure boot is set through the BIOS when UEFI is set, but it started beeping when I started. I was looking for a solution and found that I should change the main disk from MBR to GPT, which I did, but I need UEFI for that, I set it up and it keeps beeping. Sometimes it starts windows, but when I pressed the button to get into the BIOS, nothing... I need help please, the most important thing is that I want to get to

:)

 

Stuck in UEFI loop if CSM is off

I was reading on BIOS stuff cause my PC always boots to the wrong screen and a suggestion to turn CSM off fixed that but introduced a UEFI loop (every time it closes, it opens again instead of booting the system). I turned CSM back on in order to be able to boot but does anyone know why UEFI won't work?

 

My pc will not boot into windows after i change from CSM to UEFI.

*same topic thread: My pc will not boot into windows after i change from CSM to UEFI.*

My pc will not boot into windows after i change from CSM to UEFI. It boots into the bios which i recently updated and will not change untill i change back to CSM. I have a AMD motherbboard i think.

 

Trouble installing windows 7 on RAID in UEFI

As the title says, I'm trying to install Windows on a RAID array in uefi on my Maximus V Formula. When using legacy ROM I can install just fine but I go into CSM and change settings to UEFI only, I can build the array in the UEFI Raid driver (IRST tab in "BIOS") but the array does not show up in the boot menu and when I try to install windows (boot from UEFI DVD drive), The drive does not show up in the Windows install. The next thing I tried was to enable UEFI and legacy oprom in CSM, boot from UEFI DVD drive and install to the RAID array (probably detected by legacy oprom) and it will install. After first reboot, Windows Boot manager will show up as an option in the BIOS boot menu so I set that as first boot device and reboot. I will get to the starting windows screen and then BSOD (too quick to get codes) The last thing I tried was Changing to legacy mode and installing windows to a different drive. once installed, I initialized the Raid array as GPT and rebooted, changed csm back to UEFI only but they RAID array still doesn't show in the boot device list so I repeated the earlier process hoping that It might work because I had initialized as GPT but it still BSODs on starting windows screen. Any help or suggestions would be greatly appreciated