Windows 10: Computer fails to boot windows and reset this pc does not work need hel pto fix this.

Hi so basically my computer is just not booting so I decided to have a fresh install of windows put. The only problem is it gives me "There was a problem resetting your PC. No changes were made. Not much I can do as I cannot boot into windows and troubleshooting does not work. Would appreciate any help anyone can provide to help me fix this issue.

:)

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

Windows 10 "Reset this PC" failed upon final boot.

Hi Cathy,

Failing to reset the PC may happen due to several reasons. To isolate your issue, kindly answer the following questions:

• Were you able to boot using the ISO file that you downloaded?
• What troubleshooting steps have you done so far?

When booting the PC using USB recovery tool, please make sure that the first boot source in your PC's BIOS is the USB drive and not the hard drive. It is best to re-download the ISO file to make sure that you have the latest version.

Keep us updated with the status of this concern and we'll be glad to assist you further.

 

Schiit Hel usb DAC not recognized

I have been having similar issues in Windows 11 with my Hel 2, and while it's not pretty the following has worked for me:

1. Unplug the USB from the computer and flip the DAC power off
   
2. Power the DAC back on and wait a minute
   
3. Plug the USB back in
   

When that fails (and it does sometimes with symptoms of popping/crackling sounds and audio skipping) SHUT DOWN Windows, don't restart do a full power off, power off the DAC, boot Windows back up then power on the DAC. Really irritating, I am certain it's not an issue with the DAC as it works flawlessly on the same computer/USB port in Ubuntu and it only started happening recently after some update.