Windows 10: Computer freezes while using two RAM at a time.

Computer freezes in Windows loading screen. PC has to be turned off directly by turning off the main line. Removing either of the 2 RAM made everything work fine again. The problem starts only when using dual channel RAM. RAM has been tested with Memtest, windows memory test, I have tested it with 2 RAM separately, also done RAM slot swapping and no problem was found. Both RAM works fine in any slots. Check SFC, CHKDSK, Reset BIOS, RAM Voltage increase nothing happened. Solution please Processor: Intel core i5 4570 Mobo: Asus H81M-E RAM: ADATA 4GB 1600 + Twinmos 4GB 1600 same configuratio

:)

 

Windows 10 Computer Randomly Freezes

Hi,

Listed below are some possibilities why the computer keeps on freezing:

• Outdated drivers.
• Virus and malware.
• Corrupted system files.

We suggest performing the steps on this article that can help resolve the issue.

Get back to us if you have other concerns.

 

Proper RAM Timings help for corsair vengeance lpx

So I built a gaming pc recently and it has been having issues (occasionally freezing in game for unknown reasons) Now someone suggested I run memtest, but before I run it, I just want to know if my RAM timings seem correct. I have one issue, though. My RAM (Corsair LPX Vengeance 2400mhz 2x8gb =16gb) is rated at 2400mhz, but my motherboard (asus b150 pro gaming aura) can only support until 2133mhz so I am stuck at 2133. The RAM timing in corsair's website is

• Tested Latency: 14-16-16-31(2400mhz)

but according to cpu-z my timings are
NOTE: 2133mhz
CAS# LATENCY 15.0 clocks
RAS# to CA # DELAY 15 clocks
RAS# PRECHARGE (tRP) 15 clocks
Cycle Time 36 clocks

so if I am correct 15-15-15-36?
Question: Is this correct or could this be the cause of my game freezing or if memtest shows some errors could it just be caused by wrong ram timings?

 

AMD FX OC'ers Club

That's what the auto setting will do since you're over the 1333 mark it jumps to the next step which isn't listed or officially supported I assume by that ram.

At this point though I would suggest dropping the multi one step or .5 so that we can get something stable and possibly take the heat issue out of the picture for now.