Windows 10: Computer keeps having BSOD even after resetting

Hello!My computer keeps on having BSOD with PAGE_FAULT_IN_NONPAGED_AREA ntoskrnl.exe / ntkrnlmp.exe and sometimes UNEXPECTED_KERNEL_MODE_TRAP and SYSTEM_SERVICE_EXCEPTION acpi.sys / wimfsf.sys.I have tried doing sfc scannow, dism restore health, memory diagnostic tool, chkdsk, unchecking automatically manage paging file size, and have resetted windows several times and even tried reverting back to windows 10 and reformatting the whole drive. I am not doing any cpu or gpu overclock and have tried switching between xmp and default ram settings.Attached in this link is the 3 minidump files on

:)

 

Bios keeps resetting...not the battery

I'm having problems with a abit AW9D Max board in an older build of mine that keeps resetting the bios everytime I shut it down. The time is ok so I assume it's not the battery but the other settings such as Uguru setting, ram and other stuff resets to defaults*Wtf :wtf: I've had this computer for a few years with nothing like this happening till now. I'd just leave everything at default but the Uguru alarm goes off whenever I start it and I have to disable it in the bios. Any suggestions on what I can try?

 

Computer keeps crashing and having BSoD.

So I tried the driver verifier, my computer hasn't crashed yet. I did it step by step, and I'm understanding that I need to wait for my computer to crash so I can find out this devious little driver?

Edit: My PC just crashed, but it doesn't give me a BSoD. It simply... Crashes.

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".