Windows 10: Computer keeps losing video signal

I've stress tested it with 3dmark and also uninstalled my graphics drivers with DDU i also reinstalled the drivers, and updated my BIOS, and ran sfc /scannow and the DISM commands in command prompt. i have looked in event viewer and it says The computer has rebooted from a bugcheck. The bugcheck was: 0x00000116 0xffffbb879a61b010, 0xfffff80289d0bb30, 0xffffffffc000009a, 0x0000000000000004. A dump was saved in: C:\WINDOWS\Minidump\061424-8546-01.dmp. Report Id: eeec75b9-f706-45d5-ad91-d0370656d940. I have uploaded my minidump to Google Drives here is the link https://drive.google.com/drive/f

:)

 

Screens suddenly losing signal.

Hi,

No signal issues or screens losing signal may occur due to the following reasons:

• Broken or loose cables
  
• Defective or outdated video cards
• Faulty ports
• Incorrect video setup or settings

Error 0x800700B7 means that there is a system restore error. To further rectify your concern in screens losing its signal, we advise checking and updating your video drivers. Refer to
Andre Da Costa's Wiki article: How to: Install and Update drivers
in Windows 10 for the procedures. This will serve as your guide in ensuring that your video card drivers are all updated.

Let us know if you need additional assistance.

 

xbox 360 splitting video signal

Hello,

I just happened to come over your post.

Could you please tell us exactly where you don't get any signal? Both the screen and the computer (via capture device)?

Have you tried the following?

• Make sure you get a signal to the screen when using an HDMI cable directly from the Xbox 360 to the screen. Please make sure all cables work.
• Make sure you get a signal to the capture card with the same cables.

If you get a signal on the screen but not on the computer, could you please try the following?

• Set the Xbox 360 to output at 720p. The frame rate will (or should) be 59.94.
• If possible, make sure you capture the video with the same settings on the computer.
• Try any other settings if this does not work.

If it still does not work, please try this in the same order:

• Power off computer (and capture device) and Xbox 360.
• Power on computer (and capture device) and wait until the capture device is properly powered on and initialized.
• Power on the Xbox 360.
• Make sure you can capture properly.

If it still does not work, make sure that one or more of the following are not defective:

• The HDMI-VGA/composite adapter.
• The VGA cable.
• The capture device (could be just the input connector).

If that works, please install the HDMI splitter.

I am wondering a bit why you show us the wires inside the HDMI cable. Did you remove the isolation and/or do something with the wires?

I am not sure what else to suggest at the moment.

Could you please tell me/us the model of your capture device, and also the adapter between the HDMI cable and capture device?

Regards,
awd_

 

Monitor loses video signal

I have a cce tv that i use as a monitor and when i turn on the pc there is no video normally only after i press the mouse several times, and while i do that the monitor turns off and i turn it on, and i keep trying until i get the video signal. I have an hdmi connection over a video card graphics card amd radeon r5 230 (2.0 gb) - windows 10 21h2 thanks to anyone who can help me