Windows 10: Computer not reading USB recovery drive

Andre,

I went through the steps to create a recovery drive on a USB stick per your instructions, changed the boot order, but the computer will not boot from the USB drive to begin recovery on a fresh hard drive. What am I missing?

Thank you.

Paul

:)

 

How to reformat USB Recovery Drive

Part of the commands and results were missing from the image.

Open adminstrative command prompt and type or copy and paste:
diskpart
list disk
select disk #
(replace # with the disk number for the flash drive)
attributes disk clear readonly
exit


If the above steps work then you are set.
If the above steps fail then view this link for additional troubleshooting steps:
How to Format Read-only USB Drive Successfully?

 

How to reformat USB Recovery Drive

Thanks again for helping. Yes, I've found and tried those instructions prior to posting. Nothing seems to work. It is ridiculous that Windows basically trashes a perfectly good USB stick when it creates a recovery disk. Their should be a way to clear it off so you can use it again but I guess not. Probably going to just give up and toss it....they are cheap enough these days.

 

Recovery Drive for Windows 10 Doesn't Recognize USB Drive

When I try to create a Recovery Drive in Windows 10, Windows doesn't recognize the flash drive.

I'm following the instructions to create a Recovery Drive listed here:

http://windows.microsoft.com/en-us/windows-10/create-a-recovery-drive

• 
  From the taskbar, search for Create a recovery drive and then select it. You might be asked to enter an admin password or confirm your choice. (I was asked to confirm my choice, and I clicked "Yes".)
  
• 
  When the tool opens, make sure Back up system files to the recovery drive is selected and then select
  Next.
  
• 
  (Secret Step) Wait a minute or so for the "Please Wait" screen to finish thinking
  
• 
  Connect a USB drive to your PC, select it ...
  

The issue is that when I connect a USB drive to the PC, it doesn't appear on the "Connect a USB flash drive" screen as a drive that can be selected, and the "Next" button is grayed out.

However, when I look in File Explorer, I can see the USB drive plugged into the computer. Selecting Properties shows that Windows considers its Type to be "Removable Disk". (Sounds right to me.)

I'm not getting any error messages.

My environment:

A brand new Toshiba Sattelite C55-C5241 laptop with Windows 10 Home. It's never had anything other than Windows 10 on it - unless they upgraded it at the factory.

A brand new ativa 8GB USB flash drive. Note that the packaging for the USB drive does not include Windows 10 in the System Requirements, but seriously?

What I've tried:

• Plugging the flash drive into all three USB ports (USB 2, USB 2, and USB 3)
• Reformatting the flash drive with FAT32
• Restarting the computer with the flash drive plugged in
• Turning off Real-Time Scanning in McAffee

I've seen a few threads with this issue in Windows 8, but none of the potential solutions in those threads have worked for me. So here I am asking the same question, but for Windows 10.

Does anyone have any suggestions for resolving this issue?

Thank you.