Windows 10: Computer stuck at start.. now nothing.

My computer recently started just going to the very beginning loading screen where it says gigabyte and ultradurable when I power it up. I went into bios and ended up disabling ufei i think it was called trying to figure it out. Once i restarted my computer all lights turned on but nothing would happen. Not sure what to do now as i cant even get into my bios.

:)

 

is it possible to hand build a motherboard?

Might I suggest you simply build a computer, making notes and taking pictures step by step. Most people (probably including your teacher) have no idea even where to start building a computer. You'll do fine, and if you get stuck we're here to help ya out! *Toast :toast:

 

windows update stuck at installation screen and cannot get to desktop

Hi Sue,

To understand the issue better, I would like to ask some questions:

• Is the computer stuck in the Installing updates screen?
• For how long is the computer stuck in the screen?
• When was the computer last updated?
• Is the screen showing any percentage of installation?

Sometimes the installation might take a long time to install if the update is of large size. So, I suggest you to wait for sometime and check if the system boots to the desktop. If it is taking a longer time, then perform a Power Drain by following the steps
provided below:

• Shut down the Computer.
• Remove all power source (including battery if it is a laptop).
• Press and hold the power button for 15-20 seconds.
• Connect the power source and start the computer.
• After the computer boots to the desktop, suggest you to install all the pending updates.

Hope this helps. Keep us posted on the status for further assistance.

Thank you.

 

Stuck on Windows 10 start-up

Hi Kyle,

There are several reasons why you are experiencing this issue, one of those is due to outdated drivers. However, we need to perform some troubleshooting steps to isolate the cause of this concern. Before we proceed, kindly answer the following:

• Did you notice any changes on the computer prior to this concern?
• Aside from clicking the ESC button, what troubleshooting steps have you tried so far?

In the meantime, we suggest that you boot the computer in Safe Mode. This will start your Windows in a basic state, using a limited set of files and drivers. Please follow the steps provided on this

link.

Please post back with the result for further assistance.