Windows 10: Computer stuck on scan and repair 100% complete- manually initiated scan and repair.

I have initiated a scan and repair on my C drive due to the fact that I cannot play certain games without crashes or just the inability to complete the launch of the game. The scan and repair went smoothly but I am now stuck on the screen: Scanning and repairing drive C:: 100% complete. Is it ok if I restart the computer. I’ve spent quite a bit of money on this computer and would prefer not to brick it due to an error on my part.

:)

 

Scanning and Repairing Drive C 100% Complete - STUCK

When my computer does a chkdsk /r, and restarts, the scan will get stuck on 100%. I've let it sit for over 16 hours and it stays stuck. If I hit the reset button, it''ll restart, the Scanning and Repairing Drive C 100% Complete momentarily comes up, but then it moves forward and boots up to my desktop. I see this is a known problem and have tried several different so called solutions I've found on the internet to no avail. Can anyone help me?

 

Scanning and Repairing Drive C 100% Complete - STUCK

OK... I went in and checked the results of a CHKDSK. The only thing that I could see that was puzzling was that I saw this:

WARNING! /F parameter not specified.

So I did this check...





F: is a DVD drive as is E:

You can see that they come up differently and I'm not sure why a DVD drive would come up as NTFS.

Could the CHKDSK be hanging up due to CHKDSK seeing the F: as NTFS?

My Computer shows it correctly:





I went into Computer Management and everything looks good too.




--------------------------------

I ran Macrorit Diskscanner on my c: and it came back as fine, no damage. (100% good)

The only issue that I know about my c: is that when I first purchased it, it had 1 bad block. When I contacted the manufacturer, they stated that 1 bad block is OK. I have had the SSD for a few years now and never had an issue with it. the bad block does come up in Acronis Drive Monitor under Reallocated Sectors Count as Degradation, but the health is good at 98%.

I did check the drive in CrystalDiskInfo as you requested and here is a screen shot:






BTW, I appreciate that you are trying to help me figure this out. When my computer has issues, it bugs the crap out of me until I can figure out how to resolve the issue. So, thank you.

 

Stuck on "scanning and repairing drive (c: 100% complete"

so yesterday i went to reset my computer and i got to the part where it said "scanning and repairing drive (c: 100% complete" it got to 100% pretty fast but after that it never moved it has been stuck like this for around 15 hours what do i do?