Windows 10: Computer unable to update, gets stuck in cycle of attempting to update and then failing on...

For a few months now, my computer has had windows updates to install but they always fail. This makes restarting the computer very slow since I have to wait for the updates to fail over and over before it allows me to log in. Checking the log these are some of the updates that I think it is having trouble with,2023-07 Cumulative Update for Windows 10 Version 22H2 for x64-based Systems KB50281662023-07 Cumulative Update Preview for Windows 10 Version 22H2 for x64-based Systems KB5028244Microsoft .NET Framework 4.8.1 for Windows 10 Version 22H2 for x64 KB5011048I've tried to fix this issue

:)

 

Windows 7 Update stuck in failed update cycle

Windows is stuck in a loop where the computer reboots to complete the windows update. Then flashes a fail update message and that is backing out the update only to repeat the cycle endlessly. Rebooted with Windows CD but same problem after the computer
is rebooted from hard disk.

 

Task Switcher randomly gets stuck cycling windows


Good morning!

I am having an issue with the Task Switcher (see image below) activating on its own. It then begins to cycle through the open tasks very rapidly. When this happens I am unable to actually select any of the tasks, nor can I close them out. Windows is essentially frozen at this point and I have to restart.

A few things to note:

• I am running Windows 10 Pro.
• This happens randomly, sometimes weeks between an incident.
• Sometimes it happens while I am not even working at the computer. I've noticed it after returning to my desk.

Any ideas or suggestions would be greatly appreciated!

 

Windows 7 Update stuck in failed update cycle

Have you gone to the BIOS and set up the DVD Drive as the first boot device so that it boots from the CD/DVD ???

You could also try a Systems Restore to a previous point.

This can be done in Safe Mode.

https://www.microcenter.com/tech_ce...o-run-a-system-restore-in-safe-mode-windows-7