Windows 10: confused - at - Create Restore Point, after Disk C:/ cloned

confused - at - Create Restore Point, after Disk C:/ clonedsee shotI get two c:/ drives in Create Restore Point, why this, and what is the solution??? The Disk C:/ before cloned was Protection: On...

:)

 

Create restore point does not stop

Hi Nigel,

Restore points are usually saved in
Local Disk (C), kindly check that the Local Disk (C (System) is
selected when creating a restore point. If it is correctly selected and the issue still persists, kindly go to the
Local Group Policy Editor
and check if the
"Turn off Configuration"
and
"Turn off System Restore State"
is set to
Not configured. To do this, press
Windows key + R, type
GPEdit.msc
and hit
Enter. Go to the location
Computer Configuration > Administrative Templates > System > System Restore and check if both state is set to "Not configure".
If it is set to the correct state, perform these troubleshooting:

Check Disk:

To do this, follow these steps:

• 
  Access
  Command
  Prompt as
  Administrator.
  
• 
  Type
  chkdsk /f /r
  and hit
  Enter.
  

Run SFC Scan: 

To run an
SFC scan, follow these steps
(Kindly perform it 3 times):

• 
  Run
  Command Prompt as Administrator.  
  
• 
  Type
  sfc /scannow
  and hit
  Enter.   
  

Run DISM Tool: 

To perform
DISM, follow these steps:

• 
  Run
  Command Prompt as Administrator.  
  
• 
  Type the following command:  
  
  • 
    DISM.exe /Online /Cleanup-image /scanhealth  
    
  • 
    DISM.exe /Online /Cleanup-image /Restorehealth  
    

NOTE:
This might take a while to finish scanning.
Do not cancel (after running DISM, run SFC again 3 times).

If the issue persists, kindly provide us the screenshot of the return message so that we can investigate this matter
further.

Let us know how it goes.

Regards.

 

creating a restore point

Hi Anthony,

We understand that you're having an issue with creating a restore point. For us to further assist you, we'd like to gather additional information.

• Have you tried creating system restore point manually?
• Have you tried any troubleshooting steps before posting this concern? If yes, what are those?

If you haven't created a system restore point manually, you can refer to the article below and follow the instructions given. Disable your antivirus or security software and then try to create a system restore point manually.

Create a system restore point

Looking forward to your response.

 

Cannot create restore point

Try the first 3 steps in this link Solved: Can’t Create Restore Point in Windows 10 | 4 Ways.
You do not need Bitdefender, you have Windows Security (Defender) that comes with Windows and provides all the protection you need, it is Free and updates with Windows. Use Bitdefender's Uninstaller to remove it, as it may be causing conflict with System Restore. Then restart the comptuier, see if you can create a System Restore point. We also don't suggest depending on System Restore, as it works until you need it. We suggest you create an Image file of your computer using Macrium Reflect or your favorite Clone software and saving the image on another drive in or external to your computer or Cloud Service.